[PATCH v3 0/2] Enhance EDID quirks to allow forcing a mode

[Daniel Vetter]

On Fri, Mar 22, 2013 at 07:08:05PM -0400, Dylan Semler wrote:
> Changes in this version
>  * Uses drm_cvt_mode() instead of drm_gtf_mode() to build modeline
>  * Adds bool to specify reduced blanking to edid_quirk_force_mode
>  * Removes preferred bit from all other modes
> 
> There is at least one monitor that doesn't report its native resolution
> in its EDID block.  This enhancement extends the EDID quirk logic to
> make monitors like this "just work".
> 
> The first patch in this series sets up a new quirk list where monitors'
> correct width, height, refresh rate, and reduced blanking parameters are
> specified.  When a matching monitor is attached the full mode is
> calculated with drm_cvt_mode() and added to the connector.  The
> DRM_MODE_TYPE_PREFERRED bit is set on the new mode and unset from all
> other modes.
> 
> The first patch also defines a new quirk bit: EDID_QUIRK_FORCE_MODE.
> This bit needs to be set for the new quirk list discribed above to be
> checked.
> 
> The second patch adds the offending monitor to the quirk lists.
> 
> Dylan Semler (2):
>   drm: Enhance EDID quirks to explicitly set a mode
>   drm: Add EDID force quirk for MMT Monitor2Go HD+

Ah, missed this resend of your patches. Looks good to me, but I guess Dave
want's to have Ajax's ack, too. Anyway for the series:

Acked-by: Daniel Vetter <daniel.vetter at ffwll.ch>

Cheers, Daniel
-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch