[PATCH 2/2] drm/panfrost: Fix incorrect updating of current device frequency

[Adrián Larumbe]

It was noticed when setting the Panfrost's DVFS device to the performant
governor, GPU frequency as reported by fdinfo had dropped to 0 permamently.

There are two separate issues causing this behaviour:
 - Not initialising the device's current_frequency variable to its original
 value during device probe().
 - Updating said variable in Panfrost devfreq's get_dev_status() rather
 than after the new OPP's frequency had been retrieved in target(), which
 meant the old frequency would be assigned instead.

Signed-off-by: Adrián Larumbe <adrian.larumbe at collabora.com>
Fixes: f11b0417eec2 ("drm/panfrost: Add fdinfo support GPU load metrics")
---
 drivers/gpu/drm/panfrost/panfrost_devfreq.c | 17 +++++++++++++++--
 1 file changed, 15 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/panfrost/panfrost_devfreq.c b/drivers/gpu/drm/panfrost/panfrost_devfreq.c
index f59c82ea8870..2d30da38c2c3 100644
--- a/drivers/gpu/drm/panfrost/panfrost_devfreq.c
+++ b/drivers/gpu/drm/panfrost/panfrost_devfreq.c
@@ -29,14 +29,20 @@ static void panfrost_devfreq_update_utilization(struct panfrost_devfreq *pfdevfr
 static int panfrost_devfreq_target(struct device *dev, unsigned long *freq,
 				   u32 flags)
 {
+	struct panfrost_device *ptdev = dev_get_drvdata(dev);
 	struct dev_pm_opp *opp;
+	int err;
 
 	opp = devfreq_recommended_opp(dev, freq, flags);
 	if (IS_ERR(opp))
 		return PTR_ERR(opp);
 	dev_pm_opp_put(opp);
 
-	return dev_pm_opp_set_rate(dev, *freq);
+	err =  dev_pm_opp_set_rate(dev, *freq);
+	if (!err)
+		ptdev->pfdevfreq.current_frequency = *freq;
+
+	return err;
 }
 
 static void panfrost_devfreq_reset(struct panfrost_devfreq *pfdevfreq)
@@ -58,7 +64,6 @@ static int panfrost_devfreq_get_dev_status(struct device *dev,
 	spin_lock_irqsave(&pfdevfreq->lock, irqflags);
 
 	panfrost_devfreq_update_utilization(pfdevfreq);
-	pfdevfreq->current_frequency = status->current_frequency;
 
 	status->total_time = ktime_to_ns(ktime_add(pfdevfreq->busy_time,
 						   pfdevfreq->idle_time));
@@ -164,6 +169,14 @@ int panfrost_devfreq_init(struct panfrost_device *pfdev)
 
 	panfrost_devfreq_profile.initial_freq = cur_freq;
 
+	/*
+	 * We could wait until panfrost_devfreq_target() to set this value, but
+	 * since the simple_ondemand governor works asynchronously, there's a
+	 * chance by the time someone opens the device's fdinfo file, current
+	 * frequency hasn't been updated yet, so let's just do an early set.
+	 */
+	pfdevfreq->current_frequency = cur_freq;
+
 	/*
 	 * Set the recommend OPP this will enable and configure the regulator
 	 * if any and will avoid a switch off by regulator_late_cleanup()
-- 
2.42.0