<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW --- - Computer freezes with kernel 3.11.0 / 3.12-rc1 (with bug 68235's patches applied) when dpm=1 on r600g (Cayman)" href="https://bugs.freedesktop.org/show_bug.cgi?id=69723#c11">Comment # 11</a> on <a class="bz_bug_link bz_status_NEW " title="NEW --- - Computer freezes with kernel 3.11.0 / 3.12-rc1 (with bug 68235's patches applied) when dpm=1 on r600g (Cayman)" href="https://bugs.freedesktop.org/show_bug.cgi?id=69723">bug 69723</a> from <a class="email" href="mailto:agd5f@yahoo.com" title="Alex Deucher <agd5f@yahoo.com>"> Alex Deucher</a> <pre>(In reply to <a href="show_bug.cgi?id=69723#c10">comment #10</a>) > Just to be sure: vddc is associated only to sclk and vddci to mclk, right? > Not exactly. Mclk is tied to vddci (memory interface voltage), but both mclk and sclk (and the core display clock) are tied to vddc (core voltage). > Also, how are a new freq and a new voltage applied to the card? Are they > applied simultanously or sequentially? In the second case, we must be sure > to raise voltage before frequency when pushing the performances up, while we > should low the frequency before lowering the voltage when we are slowing > down. The actual adjustments are done by a microcontroller on the GPU. You pass a set of structures defining the performance levels within the power state to the microcontroller and the microcontroller handles the switching. It takes into account all of the ordering and chip state dependencies.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the assignee for the bug.</li> </ul> </body> </html>