<div> <div>hi.</div> <div> </div> <div> At present, I want to deploy gstreamer to omap3 beagleborad. I build gstreamer-0.10 and its plugins ( gstreamer-plugins-base,gstreamer-plugins-bad,gstreamer-plugins-good,gstreamer-plugins-ugly) using OE. then I copied all the build libraries to the board SD/MMC card which was install angstrom distro.</div> <div> </div> <div>when I test gstreamer in order to know if it can work properly, but I got an error only(the error as following): </div> <div> </div> <div>any help is appreciate! </div> <div> </div> <div> thanks!</div> <div> </div> <div><a href="mailto:root@beagleboard">root@beagleboard</a>:~# gst-inspect</div> <div>(gst-inspect-0.10:1494): GConf-WARNING **: Client failed to connect to the D-BUS<br> daemon:<br>dbus-launch failed to autolaunch D-Bus session: Autolaunch error: X11 initializa<br>tion failed.</div> <div><br>(gst-inspect-0.10:1494): GConf-WARNING **: Client failed to connect to the D-BUS<br> daemon:<br>dbus-launch failed to autolaunch D-Bus session: Autolaunch error: X11 initializa<br>tion failed.</div> <div><br>(gst-inspect-0.10:1494): GConf-WARNING **: Client failed to connect to the D-BUS<br> daemon:<br>dbus-launch failed to autolaunch D-Bus session: Autolaunch error: X11 initializa<br>tion failed.</div> <div><br>(gst-inspect-0.10:1494): GConf-WARNING **: Client failed to connect to the D-BUS<br> daemon:<br>dbus-launch failed to autolaunch D-Bus session: Autolaunch error: X11 initializa<br>tion failed.</div> <div>GConf Error: No D-BUS daemon running</div> <div>Error initializing: Error re-scanning registry , child terminated by signal</div></div>