<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEEDINFO " title="NEEDINFO --- - Not able to configure 800x600 resolution on SLED 11 SP2 using Intel Sandybridge GT1 driver." href="https://bugs.freedesktop.org/show_bug.cgi?id=59388#c15">Comment # 15</a> on <a class="bz_bug_link bz_status_NEEDINFO " title="NEEDINFO --- - Not able to configure 800x600 resolution on SLED 11 SP2 using Intel Sandybridge GT1 driver." href="https://bugs.freedesktop.org/show_bug.cgi?id=59388">bug 59388</a> from <a class="email" href="mailto:seahcw@sg.ibm.com" title="Terry <seahcw@sg.ibm.com>"> Terry</a> <pre>(In reply to <a href="show_bug.cgi?id=59388#c14">comment #14</a>) > When you set the 800x600 mode: > > [ 42.705782] [drm:drm_crtc_helper_set_config], attempting to set mode from > userspace > [ 42.705783] [drm:drm_mode_debug_printmodeline], Modeline 27:"" 0 50000 > 800 856 976 1040 600 637 643 666 0x0 0x5 > > It doesn't match up with the one computed from the EDID: > > [ 42.424119] [drm:drm_mode_debug_printmodeline], Modeline 18:"800x600" 72 > 50000 800 856 976 1040 600 637 643 666 0x40 0x5 > [ 42.424122] [drm:drm_mode_debug_printmodeline], Modeline 19:"800x600" 75 > 49500 800 816 896 1056 600 601 604 625 0x40 0x5 > [ 42.424125] [drm:drm_mode_debug_printmodeline], Modeline 17:"800x600" 60 > 40000 800 840 968 1056 600 601 605 628 0x40 0x5 > > Do you perchance have a custom mode somewhere, e.g. in xorg.confg? The xorg.conf provided is the default xorg.conf generated since installation. The only change was that "PreferredMode" was changed. I will attach another copy of the dmesg log collected after the command 'xrandr --output DP1 --mode 800x600 --rate 72.2'. Are there any ways that I can use to specify the modes?</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the QA Contact for the bug.</li> <li>You are the assignee for the bug.</li> </ul> </body> </html>