Guess Bjørn or Aleksander are those who knows... Ive only used the command line / mmcli for connecting. //M Den 5 aug 2015 5:56 em skrev Neal Gompa <ngompa13@gmail.com>: > > I'm using a Telit LN930 (Intel XMM7160 based modem). I'd prefer to not use ModemManager and use mbimcli directly. I'm not exactly sure how to do it, though. The --connect switch doesn't seem to indicate a way to do it. > > On Wed, Aug 5, 2015 at 11:50 AM, Markus Gothe <nietzsche@lysator.liu.se> wrote: >> >> Btw what kind of modem are you using? >> You can tunnel AT-commands over MBIM for Huawei as pointed out earlier on the list. >> >> //M >> >> Den 5 aug 2015 2:17 em skrev Neal Gompa <ngompa13@gmail.com>: >> > >> > Hello, >> > >> > Is there a way with mbimcli to use to multiple APNs simultaneously? One operator I've used (Verizon Wireless), apparently requires simultaneous connection to one APN (vzwims) and another APN (vzwinternet) to enable full Internet access (the modem automatically connects to vzwims as it is the one that the SIM designates for auto-registration). I've not been able to see it work properly with just the vzwinternet APN yet. I did this with a different modem that uses NCM/AT commands, but I'd like to know if this is possible with MBIM. It didn't appear obvious in ModemManager or mbimcli that it was possible. >> > >> > Thanks in advance! >> > >> > -- >> > 真実はいつも一つ！/ Always, there's only one truth! >> _______________________________________________ >> libmbim-devel mailing list >> libmbim-devel@lists.freedesktop.org >> http://lists.freedesktop.org/mailman/listinfo/libmbim-devel > > > > > -- > 真実はいつも一つ！/ Always, there's only one truth!