On Jun 6, 2015 19:50, "Markus Gothe" <<a href="mailto:nietzsche@lysator.liu.se">nietzsche@lysator.liu.se</a>> wrote: > > I discovered that the UML 295 needs sync, set format etc to come in a special sequence; if sync was run after set format things would break. > > This is most likely the case here: one should use USBpcap in Windows to sniff the setup. > I have a patch ready which will retry for some time until the modem ends up accepting my WDA Set Data Format to set 802.3. This takes up to one minute or more in the Netgear modem; during that time all the requests get ignored (they return success but state raw-ip). Then, one of the requests will succeed with 802.3 as reply, and the modem will get finally get exposed in DBus. I'll send that patch for review in the mailing list tomorrow. > > Den 6 jun 2015 14:13 skrev Markus Gothe <<a href="mailto:nietzsche@lysator.liu.se">nietzsche@lysator.liu.se</a>>: > > > > Same issue with with the 770S actually… > > However in MS Windows it does work for unknown reasons. :-/ > > Does the windows driver end up using 802.3 or raw-ip? > > //M > > > > On 06 Jun 2015, at 09:18 , Aleksander Morgado <<a href="mailto:aleksander@aleksander.es">aleksander@aleksander.es</a>> wrote: > > > > > On Sat, Jun 6, 2015 at 1:45 AM, Markus Gothe <<a href="mailto:nietzsche@lysator.liu.se">nietzsche@lysator.liu.se</a>> wrote: > > >> The ugly duckling of Sprint? Yeah it behaves like the Sprint 770S I guess... Seems like Netgear management decided to default to raw-ip after taking over from Sierra Wireless, the same happened with last fw for 340U. I am still unsure if it needed WDA or if CTL did the job. > > > > > > It's even worst; WDA Set Data Format doesn't always work, I'm still > > > trying to understand why. > > > > > > -- > > > Aleksander > > > <a href="https://aleksander.es">https://aleksander.es</a> > > > _______________________________________________ > > > libqmi-devel mailing list > > > <a href="mailto:libqmi-devel@lists.freedesktop.org">libqmi-devel@lists.freedesktop.org</a> > > > <a href="http://lists.freedesktop.org/mailman/listinfo/libqmi-devel">http://lists.freedesktop.org/mailman/listinfo/libqmi-devel</a> > > > > //Markus - The panama-hat hacker > > > > _______________________________________________ > > libqmi-devel mailing list > > <a href="mailto:libqmi-devel@lists.freedesktop.org">libqmi-devel@lists.freedesktop.org</a> > > <a href="http://lists.freedesktop.org/mailman/listinfo/libqmi-devel">http://lists.freedesktop.org/mailman/listinfo/libqmi-devel</a>