<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW --- - [nv34] [v3.14-rc3] DMA_PUSHER get 0x00029044 put 0x000184d0 state 0x80000040 (err: INVALID_CMD) push 0x00000000" href="https://bugs.freedesktop.org/show_bug.cgi?id=75569#c3">Comment # 3</a> on <a class="bz_bug_link bz_status_NEW " title="NEW --- - [nv34] [v3.14-rc3] DMA_PUSHER get 0x00029044 put 0x000184d0 state 0x80000040 (err: INVALID_CMD) push 0x00000000" href="https://bugs.freedesktop.org/show_bug.cgi?id=75569">bug 75569</a> from <a class="email" href="mailto:ronald645@gmail.com" title="Ronald <ronald645@gmail.com>"> Ronald</a> <pre>It hanged again albeit maybe less I don't know. I think it's better to close this post. I think this might be the age of the card (10 years of service). [root@delta gebruiker]# dmesg | grep -i agp [ 0.000000] Kernel command line: BOOT_IMAGE=/bzImage quiet xt_recent.ip_list_tot=6400 xt_recent.ip_pkt_list_tot=1 zswap.enabled=1 nouveau.agpmode=2 [ 1.889562] Linux agpgart interface v0.103 [ 1.889590] agpgart: Detected VIA KT400/KT400A/KT600 chipset [ 1.910421] agpgart-via 0000:00:00.0: AGP aperture is 256M @ 0xe0000000 [ 1.958357] agpgart-via 0000:00:00.0: AGP 3.5 bridge [ 1.958370] agpgart: swapper tried to set rate=x0. Setting to AGP3 x4 mode. [ 1.958380] agpgart-via 0000:00:00.0: putting AGP V3 device into 4x mode [ 1.958430] nouveau 0000:01:00.0: putting AGP V3 device into 4x mode It seems that I cannot set it lower than 4x mode -> nouveau.agpmode=2</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the assignee for the bug.</li> </ul> </body> </html>