<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - [NVCF] PWM fan speed too high" href="https://bugs.freedesktop.org/show_bug.cgi?id=80901#c39">Comment # 39</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - [NVCF] PWM fan speed too high" href="https://bugs.freedesktop.org/show_bug.cgi?id=80901">bug 80901</a> from <a class="email" href="mailto:lars@homer.se" title="Lars E Pettersson <lars@homer.se>"> Lars E Pettersson</a> <pre>OK, lets see... # ./nvapeek e114 10 0000e114: 0000021c 000000f9 00000001 00000000 sometimes I get the following answer: 0000e114: 0000021c 000000fe 00000001 00000000 I then select manual control and do the following: [root@tux nva]# ./nvapoke e118 80000005 [root@tux nva]# ./nvapeek e114 10 0000e114: 0000021c 00000005 00000001 00000000 Silent fan. Check with 'sensors' command. RPM is 0! Temperature raising! Set fan control back to old setting and fan returns to normal. Restart with the module blacklisted. [root@tux nva]# ./nvapeek e114 10 0000e114: 0000021c 000000a2 00000001 00000000 Restart with the nouveau module in place again. You asked K.-P. Schrage to use 'nvapoke e118 80000002' As I have 000000a2 I instead tried the following: [root@tux nva]# ./nvapoke e118 800000a2 (If I try 'nvapoke e118 80000002' the RPM goes down to 0 rpm, so I think that 800000a2 is correct for me to use. The RPM then stays slightly above 2000 rpm and the temperature is at about 60-65 degC, as it was before the change in the 3.15 kernel.) Not sure what all these numbers means though... :)</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the assignee for the bug.</li> </ul> </body> </html>