[pulseaudio-tickets] [Bug 101931] Alienware14 lower range sound output until pin 0x1a is set for a full deeper stereo sound output

[bugzilla-daemon at freedesktop.org]

https://bugs.freedesktop.org/show_bug.cgi?id=101931

--- Comment #7 from mohammed imran <imranmohd72 at hotmail.com> ---
(In reply to Tanu Kaskinen from comment #6)
> (In reply to mohammed imran from comment #0)
> > I have Alienware14 laptop, it has three jacks, a dedicated Mic jack, Headset
> > and Headphone jacks.
> > 
> > But in sound panel i only see, Headphone and Speakers option and input via
> > inbuilt Mic.
> 
> Alsa reports that there are two headphone jacks, but it's a known limitation
> in pulseaudio that if there are two mixer elements with the same name, only
> the first one will be used.

I have three jacks,Headphone, Headset and Mic jack, so three jacks, but
without pin set, Ubuntu shows me Headphone and Speakers (both inbuilt only).

Please refer to my attached Alienware14 manual page 3 , which i have pasted
here,

Audio •  One microphone port
•        One headphone and microphone combo port
•        One headphone/speakers port
Controller Realtek ALC3661 with Dolby Home Theater
Speaker Klipsch 2.1 powered speaker system
(stereo speakers with subwoofer)
Internal microphone support Dual digital-array microphones in camera
assembly

> 
> Pulseaudio detects the dedicated mic jack. If you don't see it in your audio
> configuration application, that may be because you don't have a mic plugged
> in, so the application hides the unavailable port.
> 
> The headset input is not detected at all, because the alsa mixer doesn't
> indicate that such input exists. The kernel driver should be fixed.
> 
> > I have to use hdajackretask to set 0x1a pin to get full sound with bass from
> > my laptops in built speakers, but loose headphone option in sound panel.

As commented above i have 
Klipsch 2.1 powered speaker system (stereo speakers with subwoofer), but to get
this woofer to work, i need to set pin to 0x1a. screen shot also attached.
> 
> The "pactl list" output shows that the headphone output is still detected,
> but headphones are not plugged in. Did you have headphones plugged in when
> you ran "pactl list" in after_pinset_again?

No, none of the jack where plugged in when i did the tests.

-- 
You are receiving this mail because:
You are the assignee for the bug.
You are the QA Contact for the bug.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.freedesktop.org/archives/pulseaudio-bugs/attachments/20170728/37739852/attachment.html>