<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - No analog speaker output since 5.0 release on ALC898 codec" href="https://bugs.freedesktop.org/show_bug.cgi?id=85446#c11">Comment # 11</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - No analog speaker output since 5.0 release on ALC898 codec" href="https://bugs.freedesktop.org/show_bug.cgi?id=85446">bug 85446</a> from <a class="email" href="mailto:gilles.dartiguelongue@esiee.org" title="Gilles Dartiguelongue <gilles.dartiguelongue@esiee.org>"> Gilles Dartiguelongue</a> <pre>(In reply to Raymond from <a href="show_bug.cgi?id=85446#c7">comment #7</a>) > D: [pulseaudio] alsa-mixer.c: Removing path 'analog-output' as it is a > subset of 'analog-output-lineout'. > > analog-output still exist after pulseaudio print the above message during > probing profile: stereo, 2.1, 4.0, 4.1,5.0,5.1 and 7.1 "Problem" is that "Line Out - Built in" is the entry holding the 2.0, 4.0 4.1, ..., 7.1 profiles. The other one just has 2.1. Not sure if this is correct either since I only have 2.0 jack connected. > need to enable log-time in daemon.conf , seem client did not supply enough > data as pulseaudio start cutting sleeping time by half Done.</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the QA Contact for the bug.</li> <li>You are the assignee for the bug.</li> </ul> </body> </html>