<html> <head> <base href="https://bugs.freedesktop.org/" /> </head> <body> <div> <a class="bz_bug_link bz_status_NEW " title="NEW - Assertion '!s->thread_info.rewind_requested' failed at pulsecore/sink.c:1271, function pa_sink_render_into_full(). Aborting." href="https://bugs.freedesktop.org/show_bug.cgi?id=54881#c8">Comment # 8</a> on <a class="bz_bug_link bz_status_NEW " title="NEW - Assertion '!s->thread_info.rewind_requested' failed at pulsecore/sink.c:1271, function pa_sink_render_into_full(). Aborting." href="https://bugs.freedesktop.org/show_bug.cgi?id=54881">bug 54881</a> from <a class="email" href="mailto:superquad.vortex2@gmail.com" title="Raymond <superquad.vortex2@gmail.com>"> Raymond</a> <pre>Simple mixer control 'IEC958 Default PCM',0 Capabilities: pswitch pswitch-joined penum Playback channels: Mono Mono: Playback [on] <a href="https://git.kernel.org/cgit/linux/kernel/git/tiwai/sound.git/commit/sound/pci/hda?id=9a08160bdbe3148a405f72798f76e2a5d30bd243">https://git.kernel.org/cgit/linux/kernel/git/tiwai/sound.git/commit/sound/pci/hda?id=9a08160bdbe3148a405f72798f76e2a5d30bd243</a> Added a new mixer switch to enable/disable the sharing of the default PCM stream with analog and SPDIF outputs. When "IEC958 Default PCM" switch is on, the PCM stream is routed both to analog and SPDIF outputs. This is the behavior in the earlier version. Turning this switch off has a merit for some codecs, though. Some codec chips don't support 24bit formats for SPDIF but only for analog outputs. In this case, you can use 24bit format by disabling this switch. audio output node 0x02 and node 0x06 should use same stream id Node 0x02 [Audio Output] wcaps 0x41d: Stereo Amp-Out Control: name="Front Playback Volume", index=0, device=0 ControlAmp: chs=3, dir=Out, idx=0, ofs=0 Device: name="ALC892 Analog", type="Audio", device=0 Amp-Out caps: ofs=0x40, nsteps=0x40, stepsize=0x03, mute=0 Amp-Out vals: [0x40 0x40] Converter: stream=8, channel=0 PCM: rates [0x560]: 44100 48000 96000 192000 bits [0xe]: 16 20 24 formats [0x1]: PCM Power states: D0 D1 D2 D3 EPSS Power: setting=D0, actual=D0</pre> </div> <hr> You are receiving this mail because: <ul> <li>You are the QA Contact for the bug.</li> <li>You are the assignee for the bug.</li> </ul> </body> </html>