[systemd-devel] systemd-fsck question

[Nikolai Zhubr]

Hi again,

Now a have another question.

In systemd-fsck at .service I see "StandardOutput=journal+console", and 
"StandardOutput" not set, AFAICS defaulting to "inherit" according to 
system config file, which looks good, as all diagnostic and error 
messages coming from systemd-fsck (and they are quite important) would 
therefore (supposedly) go to both journal and physical console.

Now, through fsck.c in systemd sources, I can see that any unsuccessfull 
exit (errorcode) is reasonably accompanied by some descriptive message, 
such as "Failed to stat %s" etc. Looks good.

However, here is my console log:

----------- console fragment start ----------
[  OK  ] Found device 
/dev/disk/by-uuid/7290addb-123e-44bf-96d5-eaedc37c1852.
          Starting File System Check on 
/dev/disk/by-uuid/7290...eaedc37c1852...
[  OK  ] Found device 
/dev/disk/by-uuid/4c25dd37-c555-4fbf-8349-f1470d0e924c.
[  OK  ] Started dracut initqueue hook.
          Starting dracut pre-mount hook...
[  OK  ] Reached target Remote File Systems (Pre).
[  OK  ] Reached target Remote File Systems.
[  OK  ] Started dracut pre-mount hook.
[FAILED] Failed to start File System Check on 
/dev/disk/by-uu...5-eaedc37c1852.
See "systemctl status 'systemd-fsck at dev-disk-by\x2duuid-729...ce'" for 
details.
[DEPEND] Dependency failed for /sysroot.
----------- console fragment end -----------
There are absolutely no messages relevant to systemd-fsck between 
"Starting File System Check ..." and "Failed to start File System Check 
..." ! How can this be possible, and how do I find the reason for 
failure then?

Thanks in advance,
Nikolai