[PATCH 23/33] drm/amd/display: update infoframe after dig fe is turned on

[Harry Wentland]

From: Eric Yang <Eric.Yang2 at amd.com>

Before dig fe is enabled, infoframe can't be programmed. So in
suspend resume case our infoframe programmming was not going through.

This change changes the sequence so that infoframe is programmed
after.

Signed-off-by: Eric Yang <Eric.Yang2 at amd.com>
Reviewed-by: Tony Cheng <Tony.Cheng at amd.com>
Acked-by: Harry Wentland <harry.wentland at amd.com>
---
 .../amd/display/dc/dce110/dce110_hw_sequencer.c    | 23 ++++++++++++----------
 1 file changed, 13 insertions(+), 10 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/dc/dce110/dce110_hw_sequencer.c b/drivers/gpu/drm/amd/display/dc/dce110/dce110_hw_sequencer.c
index f21aa04e93da..c2041a63cccd 100644
--- a/drivers/gpu/drm/amd/display/dc/dce110/dce110_hw_sequencer.c
+++ b/drivers/gpu/drm/amd/display/dc/dce110/dce110_hw_sequencer.c
@@ -684,15 +684,22 @@ void dce110_enable_stream(struct pipe_ctx *pipe_ctx)
 	struct dc_crtc_timing *timing = &pipe_ctx->stream->timing;
 	struct dc_link *link = pipe_ctx->stream->sink->link;
 
-	/* 1. update AVI info frame (HDMI, DP)
-	 * we always need to update info frame
-	*/
+
 	uint32_t active_total_with_borders;
 	uint32_t early_control = 0;
 	struct timing_generator *tg = pipe_ctx->stream_res.tg;
 
-	/* TODOFPGA may change to hwss.update_info_frame */
+	/* For MST, there are multiply stream go to only one link.
+	 * connect DIG back_end to front_end while enable_stream and
+	 * disconnect them during disable_stream
+	 * BY this, it is logic clean to separate stream and link */
+	link->link_enc->funcs->connect_dig_be_to_fe(link->link_enc,
+						    pipe_ctx->stream_res.stream_enc->id, true);
+
+	/* update AVI info frame (HDMI, DP)*/
+	/* TODO: FPGA may change to hwss.update_info_frame */
 	dce110_update_info_frame(pipe_ctx);
+
 	/* enable early control to avoid corruption on DP monitor*/
 	active_total_with_borders =
 			timing->h_addressable
@@ -713,12 +720,8 @@ void dce110_enable_stream(struct pipe_ctx *pipe_ctx)
 			pipe_ctx->stream_res.stream_enc->funcs->dp_audio_enable(pipe_ctx->stream_res.stream_enc);
 	}
 
-	/* For MST, there are multiply stream go to only one link.
-	 * connect DIG back_end to front_end while enable_stream and
-	 * disconnect them during disable_stream
-	 * BY this, it is logic clean to separate stream and link */
-	link->link_enc->funcs->connect_dig_be_to_fe(link->link_enc,
-						    pipe_ctx->stream_res.stream_enc->id, true);
+
+
 
 }
 
-- 
2.14.1