vga handover for raven

[Yang, Eric]

If there is no VGA hand over, the change should make no difference. In the VGA hand over case, the difference introduced is the following, we can try to revert this part of the commit, which should not break S3.

        REG_WRITE(D1VGA_CONTROL, 0);
-       REG_WRITE(D2VGA_CONTROL, 0);
-       REG_WRITE(D3VGA_CONTROL, 0);
-       REG_WRITE(D4VGA_CONTROL, 0);

-----Original Message-----
From: StDenis, Tom 
Sent: Wednesday, March 14, 2018 10:12 AM
To: Wentland, Harry <Harry.Wentland at amd.com>; Lakha, Bhawanpreet <Bhawanpreet.Lakha at amd.com>
Cc: amd-gfx at lists.freedesktop.org; Cheng, Tony <Tony.Cheng at amd.com>; Yang, Eric <Eric.Yang2 at amd.com>
Subject: Re: vga handover for raven

Hi Harry,

Reverting that on top of the current amd-staging-drm-next seems to have fixed the issue.

Thanks,
Tom

On 03/14/2018 10:08 AM, Harry Wentland wrote:
> On 2018-03-14 09:54 AM, Tom St Denis wrote:
>> Hi,
>>
>> In the original version of the patch we had:
>>
>> @@ -358,7 +360,9 @@ struct dce_hwseq_registers {
>>
>>          HWSEQ_PIXEL_RATE_MASK_SH_LIST(mask_sh, OTG0_),\
>>          HWS_SF1(OTG0_, PHYPLL_PIXEL_RATE_CNTL, 
>> PHYPLL_PIXEL_RATE_SOURCE, mask_sh), \
>>          HWS_SF(, DCHUBBUB_GLOBAL_TIMER_CNTL, 
>> DCHUBBUB_GLOBAL_TIMER_ENABLE, mask_sh), \
>> -       HWS_SF(, DCFCLK_CNTL, DCFCLK_GATE_DIS, mask_sh)
>>
>> +       HWS_SF(, DCFCLK_CNTL, DCFCLK_GATE_DIS, mask_sh),\
>>
>> +       HWS_SF(, VGA_TEST_CONTROL, VGA_TEST_ENABLE, mask_sh),\
>>
>> +       HWS_SF(, VGA_TEST_CONTROL, VGA_TEST_RENDER_START, mask_sh)
>>
>>
>>
>> Which somehow changed into
>>
>> @@ -404,7 +406,9 @@ struct dce_hwseq_registers {
>>          HWS_SF(, DOMAIN7_PG_STATUS, DOMAIN7_PGFSM_PWR_STATUS, 
>> mask_sh), \
>>          HWS_SF(, DC_IP_REQUEST_CNTL, IP_REQUEST_EN, mask_sh), \
>>          HWS_SF(, LVTMA_PWRSEQ_CNTL, LVTMA_BLON, mask_sh), \
>> -       HWS_SF(, LVTMA_PWRSEQ_STATE, LVTMA_PWRSEQ_TARGET_STATE_R, 
>> mask_sh)
>> +       HWS_SF(, LVTMA_PWRSEQ_STATE, LVTMA_PWRSEQ_TARGET_STATE_R, 
>> +mask_sh), \
>> +       HWS_SF(, VGA_TEST_CONTROL, VGA_TEST_ENABLE, mask_sh),\
>> +       HWS_SF(, VGA_TEST_CONTROL, VGA_TEST_RENDER_START, mask_sh)
>>
> 
> This is just defining the VGA_TEST registers for use by DC. It shouldn't have an impact on that patch.
> 
>> And the net result is the display doesn't work (same glitches as before) on a raven1 device.
>>
> 
> Can you see if reverting this commit fixes it?
> 	1b0ff66bc0bf drm/amd/display: early return if not in vga mode in 
> disable_vga
> 
> If introduced a check to see if we're actually in VGA mode and only then applied the workaround. I believe it's to avoid problems resuming from S3.
> 
> Harry
> 
>> Tom