[PATCH] drm/amdgpu: Add delay after enable RLC ucode

[Liu, Shaoyun]

Driver shouldn't try to access any GFX registers until RLC is idle.
During the test, it took 12 seconds for RLC to clear the BUSY bit
in RLC_GPM_STAT register which is un-acceptable for driver.
As per RLC engineer, it would take RLC Ucode less than 10,000 GFXCLK
cycles to finish its critical section. In a lowest 300M enginer clock
setting(default from vbios), 50 us delay is enough.

Change-Id: If074fbeeecad3f63cf5f5ab232472d0fe46082a6
Signed-off-by: shaoyunl <shaoyun.liu at amd.com>
---
 drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c b/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
index e409fbf..9686fcc 100644
--- a/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
+++ b/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
@@ -2326,12 +2326,13 @@ static void gfx_v9_0_rlc_start(struct amdgpu_device *adev)
 #endif
 
 	WREG32_FIELD15(GC, 0, RLC_CNTL, RLC_ENABLE_F32, 1);
+	udelay(50);
 
 	/* carrizo do enable cp interrupt after cp inited */
-	if (!(adev->flags & AMD_IS_APU))
+	if (!(adev->flags & AMD_IS_APU)) {
 		gfx_v9_0_enable_gui_idle_interrupt(adev, true);
-
-	udelay(50);
+		udelay(50);
+	}
 
 #ifdef AMDGPU_RLC_DEBUG_RETRY
 	/* RLC_GPM_GENERAL_6 : RLC Ucode version */
-- 
2.7.4