[PATCH] drm/amdgpu: fix gfx hang during suspend with video playback
Huang Rui
ray.huang at amd.com
Fri Apr 3 10:05:55 UTC 2020
On Fri, Apr 03, 2020 at 05:22:28PM +0800, Liang, Prike wrote:
>
> > -----Original Message-----
> > From: Huang, Ray <Ray.Huang at amd.com>
> > Sent: Friday, April 3, 2020 2:27 PM
> > To: Liang, Prike <Prike.Liang at amd.com>
> > Cc: amd-gfx at lists.freedesktop.org; Quan, Evan <Evan.Quan at amd.com>;
> > Deucher, Alexander <Alexander.Deucher at amd.com>; Kuehling, Felix
> > <Felix.Kuehling at amd.com>
> > Subject: Re: [PATCH] drm/amdgpu: fix gfx hang during suspend with video
> > playback
> >
> > (+ Felix)
> >
> > On Fri, Apr 03, 2020 at 12:07:53PM +0800, Liang, Prike wrote:
> > > The system will be hang up during S3 as SMU is pending at GC not
> > > respose the register CP_HQD_ACTIVE access request and this issue can
> > > be fixed by adding RLC safe mode guard before each HQD map/unmap
> > > retrive opt.
> >
> > We need more information for the issue, does the map/unmap is required
> > for MAP_QUEUES/UNMAP_QUEUES packets or writing with MMIO or both?
> >
> [Prike] The issue hang up at MP1 was trying to read register RSMU_RESIDENCY_COUNTER_GC
> but did not get response from GFX, since GFX was busy at reading register CP_HQD_ACTIVE.
> Moreover, when disabled GFXOFF this issue also can't see so there is likely to perform
> register accessed at GFXOFF CGPG/CGCG enter stage. As for only this issue, that seems just
> MMIO access failed case which occurred under QUEUE map/unmap status check.
>
While we start to do S3, we will disable gfxoff at start of suspend. Then
in this point, the gfx should be always in "on" state.
> > From your patch, you just protect the kernel kiq and user queue. What about
> > other kernel compute queues? HIQ?
> >
> [Prike] So far just find the KIQ/CPQ/DIQ map/unmap will inquire the CP_HQD_ACTIVE status by MMIO accessing,
> therefore just guard the KIQ and some type user queue now. Regarding HIQ map and ummap which used the method of submitting configuration packet.
>
KIQ itself init/unit should be always under gfx on state. Can you give a
check the result if not add enter/exit rlc safe mode around it?
Hi Felix, maybe we need to use packets with kiq to map all user queues.
Thanks,
Ray
> > Thanks,
> > Ray
> >
> > >
> > > Signed-off-by: Prike Liang <Prike.Liang at amd.com>
> > > Tested-by: Mengbing Wang <Mengbing.Wang at amd.com>
> > > ---
> > > drivers/gpu/drm/amd/amdgpu/amdgpu_amdkfd_gfx_v9.c | 6 ++++++
> > > drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c | 4 ++++
> > > 2 files changed, 10 insertions(+)
> > >
> > > diff --git a/drivers/gpu/drm/amd/amdgpu/amdgpu_amdkfd_gfx_v9.c
> > > b/drivers/gpu/drm/amd/amdgpu/amdgpu_amdkfd_gfx_v9.c
> > > index df841c2..e265063 100644
> > > --- a/drivers/gpu/drm/amd/amdgpu/amdgpu_amdkfd_gfx_v9.c
> > > +++ b/drivers/gpu/drm/amd/amdgpu/amdgpu_amdkfd_gfx_v9.c
> > > @@ -232,6 +232,7 @@ int kgd_gfx_v9_hqd_load(struct kgd_dev *kgd, void
> > *mqd, uint32_t pipe_id,
> > > uint32_t *mqd_hqd;
> > > uint32_t reg, hqd_base, data;
> > >
> > > + amdgpu_gfx_rlc_enter_safe_mode(adev);
> > > m = get_mqd(mqd);
> > >
> > > acquire_queue(kgd, pipe_id, queue_id); @@ -299,6 +300,7 @@ int
> > > kgd_gfx_v9_hqd_load(struct kgd_dev *kgd, void *mqd, uint32_t pipe_id,
> > >
> > > release_queue(kgd);
> > >
> > > + amdgpu_gfx_rlc_exit_safe_mode(adev);
> > > return 0;
> > > }
> > >
> > > @@ -497,6 +499,7 @@ bool kgd_gfx_v9_hqd_is_occupied(struct kgd_dev
> > *kgd, uint64_t queue_address,
> > > bool retval = false;
> > > uint32_t low, high;
> > >
> > > + amdgpu_gfx_rlc_enter_safe_mode(adev);
> > > acquire_queue(kgd, pipe_id, queue_id);
> > > act = RREG32(SOC15_REG_OFFSET(GC, 0, mmCP_HQD_ACTIVE));
> > > if (act) {
> > > @@ -508,6 +511,7 @@ bool kgd_gfx_v9_hqd_is_occupied(struct kgd_dev
> > *kgd, uint64_t queue_address,
> > > retval = true;
> > > }
> > > release_queue(kgd);
> > > + amdgpu_gfx_rlc_exit_safe_mode(adev);
> > > return retval;
> > > }
> > >
> > > @@ -541,6 +545,7 @@ int kgd_gfx_v9_hqd_destroy(struct kgd_dev *kgd,
> > void *mqd,
> > > uint32_t temp;
> > > struct v9_mqd *m = get_mqd(mqd);
> > >
> > > + amdgpu_gfx_rlc_enter_safe_mode(adev);
> > > if (adev->in_gpu_reset)
> > > return -EIO;
> > >
> > > @@ -577,6 +582,7 @@ int kgd_gfx_v9_hqd_destroy(struct kgd_dev *kgd,
> > void *mqd,
> > > }
> > >
> > > release_queue(kgd);
> > > + amdgpu_gfx_rlc_exit_safe_mode(adev);
> > > return 0;
> > > }
> > >
> > > diff --git a/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
> > > b/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
> > > index 1fea077..ee107d9 100644
> > > --- a/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
> > > +++ b/drivers/gpu/drm/amd/amdgpu/gfx_v9_0.c
> > > @@ -3533,6 +3533,7 @@ static int gfx_v9_0_kiq_init_register(struct
> > amdgpu_ring *ring)
> > > struct v9_mqd *mqd = ring->mqd_ptr;
> > > int j;
> > >
> > > + amdgpu_gfx_rlc_enter_safe_mode(adev);
> > > /* disable wptr polling */
> > > WREG32_FIELD15(GC, 0, CP_PQ_WPTR_POLL_CNTL, EN, 0);
> > >
> > > @@ -3629,6 +3630,7 @@ static int gfx_v9_0_kiq_init_register(struct
> > amdgpu_ring *ring)
> > > if (ring->use_doorbell)
> > > WREG32_FIELD15(GC, 0, CP_PQ_STATUS, DOORBELL_ENABLE,
> > 1);
> > >
> > > + amdgpu_gfx_rlc_exit_safe_mode(adev);
> > > return 0;
> > > }
> > >
> > > @@ -3637,6 +3639,7 @@ static int gfx_v9_0_kiq_fini_register(struct
> > amdgpu_ring *ring)
> > > struct amdgpu_device *adev = ring->adev;
> > > int j;
> > >
> > > + amdgpu_gfx_rlc_enter_safe_mode(adev);
> > > /* disable the queue if it's active */
> > > if (RREG32_SOC15(GC, 0, mmCP_HQD_ACTIVE) & 1) {
> > >
> > > @@ -3668,6 +3671,7 @@ static int gfx_v9_0_kiq_fini_register(struct
> > amdgpu_ring *ring)
> > > WREG32_SOC15_RLC(GC, 0, mmCP_HQD_PQ_WPTR_HI, 0);
> > > WREG32_SOC15_RLC(GC, 0, mmCP_HQD_PQ_WPTR_LO, 0);
> > >
> > > + amdgpu_gfx_rlc_exit_safe_mode(adev);
> > > return 0;
> > > }
> > >
> > > --
> > > 2.7.4
> > >
More information about the amd-gfx
mailing list