[PATCH 45/67] drm/amd/display: use preferred link settings for dp signal only

[Zaeem Mohamed]

From: Wenjing Liu <wenjing.liu at amd.com>

[why]
We set preferred link settings for virtual signal. However we don't support
virtual signal for UHBR link rate. If preferred is set to UHBR link rate, we
will allow virtual signal with UHBR link rate which causes system crashes.

Reviewed-by: Dillon Varone <dillon.varone at amd.com>
Acked-by: Zaeem Mohamed <zaeem.mohamed at amd.com>
Signed-off-by: Wenjing Liu <wenjing.liu at amd.com>
---
 .../dc/link/protocols/link_dp_capability.c    | 24 ++++++++-----------
 1 file changed, 10 insertions(+), 14 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c b/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
index 41bdadc585b3..00974c50e11f 100644
--- a/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
+++ b/drivers/gpu/drm/amd/display/dc/link/protocols/link_dp_capability.c
@@ -930,21 +930,17 @@ bool link_decide_link_settings(struct dc_stream_state *stream,
 
 	memset(link_setting, 0, sizeof(*link_setting));
 
-	/* if preferred is specified through AMDDP, use it, if it's enough
-	 * to drive the mode
-	 */
-	if (link->preferred_link_setting.lane_count !=
-			LANE_COUNT_UNKNOWN &&
-			link->preferred_link_setting.link_rate !=
-					LINK_RATE_UNKNOWN) {
+	if (dc_is_dp_signal(stream->signal)  &&
+			link->preferred_link_setting.lane_count != LANE_COUNT_UNKNOWN &&
+			link->preferred_link_setting.link_rate != LINK_RATE_UNKNOWN) {
+		/* if preferred is specified through AMDDP, use it, if it's enough
+		 * to drive the mode
+		 */
 		*link_setting = link->preferred_link_setting;
-		return true;
-	}
-
-	/* MST doesn't perform link training for now
-	 * TODO: add MST specific link training routine
-	 */
-	if (stream->signal == SIGNAL_TYPE_DISPLAY_PORT_MST) {
+	} else if (stream->signal == SIGNAL_TYPE_DISPLAY_PORT_MST) {
+		/* MST doesn't perform link training for now
+		 * TODO: add MST specific link training routine
+		 */
 		decide_mst_link_settings(link, link_setting);
 	} else if (link->connector_signal == SIGNAL_TYPE_EDP) {
 		/* enable edp link optimization for DSC eDP case */
-- 
2.34.1