[PATCH 18/27] drm/amd/display: Use drm_err() instead of DRM_ERROR in dm_resume()

[Wayne Lin]

From: Mario Limonciello <mario.limonciello at amd.com>

drm_err() is helpful to show which device had the error. Adjust to
using this instead for error messages.

Reviewed-by: Alex Hung <alex.hung at amd.com>
Signed-off-by: Mario Limonciello <mario.limonciello at amd.com>
Signed-off-by: Wayne Lin <wayne.lin at amd.com>
---
 drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
index 6e218e69f039..3bf09c17ce85 100644
--- a/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
+++ b/drivers/gpu/drm/amd/display/amdgpu_dm/amdgpu_dm.c
@@ -3376,7 +3376,7 @@ static int dm_resume(struct amdgpu_ip_block *ip_block)
 
 		r = dm_dmub_hw_init(adev);
 		if (r)
-			DRM_ERROR("DMUB interface failed to initialize: status=%d\n", r);
+			drm_err(adev_to_drm(adev), "DMUB interface failed to initialize: status=%d\n", r);
 
 		dc_dmub_srv_set_power_state(dm->dc->ctx->dmub_srv, DC_ACPI_CM_POWER_STATE_D0);
 		dc_set_power_state(dm->dc, DC_ACPI_CM_POWER_STATE_D0);
@@ -3469,7 +3469,7 @@ static int dm_resume(struct amdgpu_ip_block *ip_block)
 
 		mutex_lock(&aconnector->hpd_lock);
 		if (!dc_link_detect_connection_type(aconnector->dc_link, &new_connection_type))
-			DRM_ERROR("KMS: Failed to detect connector\n");
+			drm_err(adev_to_drm(adev), "KMS: Failed to detect connector\n");
 
 		if (aconnector->base.force && new_connection_type == dc_connection_none) {
 			emulated_link_detect(aconnector->dc_link);
-- 
2.37.3