dbus-send signals missed out by the dbus-service(server)

[abhijeet.sinha1 at wipro.com]

Hi all,

I am a newbie to DBUS, great concept :) . I wrote a small application - using DBUS where I call dbus-send to send a signal when my DHCP does an ACK on an IP, to send the leased ip address as a string argument attached to signal. My dbus-service listens for the particular kind of signal "com.xyz.abc.Signal" and acts on the leased ip-address received with the signal.

My problem is out of 10 signals sent only 7-8 are being received by the service. The point is the DBUS server responds but after a time lags say 20-30 seconds for the first few signals after it has been started. 

Is it a normal time lag ? Using dbus-1.0.0-7 on Centos 5.2 . The signals are of type system and not session. 


Regards,
Abhijeet Kumar Sinha
Project Engineer
Wipro Technologies 


Please do not print this email unless it is absolutely necessary. 

The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments. 

WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email. 

www.wipro.com
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.freedesktop.org/archives/dbus/attachments/20090117/208dd009/attachment.html