[Bug 33011] HDMI-A-1 Does not work after resume (But claims it does)

bugzilla-daemon at freedesktop.org bugzilla-daemon at freedesktop.org
Wed Feb 9 14:12:15 PST 2011


https://bugs.freedesktop.org/show_bug.cgi?id=33011

--- Comment #18 from Russ Dill <Russ.Dill at gmail.com> 2011-02-09 14:12:14 PST ---
Just some notes:

Power:
Maxim MAX1999 Quad-ouput main power supply controller
Maxim MAX8774GTL+ main power supply controller
Semtech SC470 synchronous buck controller
Semtech SC488 complete DDR memory power supply
Nat Semi LM393 dual comparators.

Chipset:
ATI IXP460 SB460
ATI XPRESS RX485
ATX X1600
Broadcom BCM5788 MKFBG Netlink gigabit Ethernet controller with phy
ICS ICS951462AGLF Programmable system clock chip for ATI RS/RD690 - K8 based
systems
Cypress CY25819 spread spectrum clock generator

Super IO:
Nat Semi PC87541V-VPC (Seems to be PC87591) LPC Mobile Embedded Controller
Nat Semi PC87383-VS Legacy reduced super I/O

Video:
TI TS3DV520 5-Channel differential 10:20 multiplexer switch for DVI/HDMI
applications (Single pin SEL signal)
(x2) California Micro Devices CM1213 4-channel low capacitance ESD protection
arrays
California Micro Devices CM2009 VGA port companion circuit
Silicon Image Sil1930CMU TDMS ParallelLink

uC:
Atmel AT89C51ICS-VL 8-bit flash microcontroller with 2-wire interface

Misc:
TI SN74CBT3257 4-bit 1-of-2 FET multiplexer/demultiplexer (I2C?)
Maxim MAX3892 10/100/1000 base-T ethernet LAN switch
Global Mixed-mode Technology Inc G528 USB high-side switch
Microchip 24LC08BI 8K I2C serial EEPROM
Toshiba 7W125 dual bus buffer

Audio:
Realtek ALC833 Value 7.1+2 HD audio codec
AKM AK4113VF 192kHz 24bit DIR with 6:1 selector
Maxim 9710E 3W Mono/Steria BTL audio power amps

-- 
Configure bugmail: https://bugs.freedesktop.org/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.


More information about the dri-devel mailing list