[RESEND PATCH v3 06/11] drm: add DT bindings documentation for atmel-hlcdc-dc driver

Laurent Pinchart laurent.pinchart at ideasonboard.com
Mon Jul 21 02:32:55 PDT 2014


Hi Boris,

On Monday 21 July 2014 11:24:38 Boris BREZILLON wrote:
> On Mon, 21 Jul 2014 10:59:12 +0200 Thierry Reding wrote:
> > On Fri, Jul 18, 2014 at 05:43:34PM +0200, Boris BREZILLON wrote:
> > [...]
> > 
> >>>>>>> + - atmel,panel: Should contain a phandle with 2 parameters.
> >>>>>>> +   The first cell is a phandle to a DRM panel device
> >>>>>>> +   The second cell encodes the RGB mode, which can take the
> >>>>>>> following values:
> >>>>>>> +   * 0: RGB444
> >>>>>>> +   * 1: RGB565
> >>>>>>> +   * 2: RGB666
> >>>>>>> +   * 3: RGB888
> >>>>>> 
> >>>>>> These are properties of the panel and should be obtained from
> >>>>>> the panel directly rather than an additional cell in this specifier.
> >>>>> 
> >>>>> Okay.
> >>>>> What's the preferred way of doing this ?
> >>>>> What about defining an rgb-mode property in the panel node.
> >>>> 
> >>>> There's .bpc in struct drm_display_info, I suspect that it could be
> >>>> used for this. Alternatively, maybe we could extend the list of color
> >>>> formats that go into drm_display_info.color_formats? RGB444 is already
> >>>> covered.
> >> 
> >> I forgot to ask about bpc meaning. If, as I think, it means "bits per
> >> color" then it cannot be used to encode RGB565 where green color is
> >> encoded on 6 bits and red and blue are encoded on 5 bits.
> > 
> > Yes, I agree that bps is not a good fit for what you need here.
> 
> Okay, then I think we can replace bpc and color_formats by a bus_formats
> table containing all supported formats, and use an enum (something
> similar to v4l2_mbus_pixelcode defined in v4l2-mediabus.h [1]) to list
> the available formats.
> 
> As this implies quite a few changes in crtc core and some drm drivers
> (nouveau, i915 and radeon), I'd like to be sure this is what both of you
> had in mind.

I think it is, but just to make sure I understand you correctly, could you 
just show how the drm_display_info structure would look like ?

-- 
Regards,

Laurent Pinchart



More information about the dri-devel mailing list