[PATCH V2 1/9] drm/exynos: dp: support hotplug detection via GPIO

[Jingoo Han]

On Tuesday, April 22, 2014 4:14 PM, Jingoo Han wrote:
> On Tuesday, April 22, 2014 7:39 AM, Ajay Kumar wrote:
> >
> > From: Andrew Bresticker <abrestic at chromium.org>
> >
> > Certain bridge chips use a GPIO to indicate the cable status instead
> > of the I_DP_HPD pin.  This adds an optional device-tree property,
> > "samsung,hpd-gpio", to the exynos-dp controller which indicates that
> > the specified GPIO should be used for hotplug detection.
> > The GPIO is then set up as an edge-triggered interrupt where the
> > rising edge indicates hotplug-in and the falling edge indicates hotplug-out.
> >
> > Signed-off-by: Andrew Bresticker <abrestic at chromium.org>
> > Signed-off-by: Rahul Sharma <rahul.sharma at samsung.com>
> > Signed-off-by: Ajay Kumar <ajaykumar.rs at samsung.com>
> 
> Acked-by: Jingoo Han <jg1.han at samsung.com>

Hi Inki Dae,

Actually, this patch is NOT related to other patches for
bridge chip support. So, would you apply this patch into
your exynos drm git with my Acked-by?

Best regards,
Jingoo Han


> 
> > ---
> > Changes since V1:
> > 	Address reiew comments from Jingoo Han
> >
> >  .../devicetree/bindings/video/exynos_dp.txt        |    4 ++
> >  drivers/gpu/drm/exynos/exynos_dp_core.c            |   32 ++++++++++++--
> >  drivers/gpu/drm/exynos/exynos_dp_core.h            |    1 +
> >  drivers/gpu/drm/exynos/exynos_dp_reg.c             |   44 ++++++++++++++------
> >  4 files changed, 66 insertions(+), 15 deletions(-)
> 
> [.....]