[PATCH v2 04/18] video: add command mode and command mode display timing

[Inki Dae]

On 2014년 05월 21일 20:41, YoungJun Cho wrote:
> Hi Therry
> 
> On 05/21/2014 08:02 PM, Thierry Reding wrote:
>> On Wed, May 21, 2014 at 01:42:56PM +0900, YoungJun Cho wrote:
>>> This patch is based on videomode and display_timing relevant codes.
>>> To support command mode panel, it does not need to guide its timing
>>> information to the display controller like video mode panel,
>>> but it requires signal timings to transfer video data.
>>> So this patch adds cmdmode struct, cmdmode_display_timing struct and
>>> the according helper functions to convert cmdmode_display_timing
>>> to a generic cmdmode.
>>
>> Can you point me to relevant documentation? I wasn't able to find it by
>> a quick scan through the DSI specification.
>>
> 
> I'm sorry to say that there is no specific one document.
> 
> I referred to several ones, CPU interface, I80 interface and
> DBI document(last time you said it).
> I think this is good to check it.
> [ http://cache.freescale.com/files/dsp/doc/app_note/AN4180.pdf ]
> 

Ping~. Is there other comment? If so then I'd like to pick them up. We
would be happy for you leave reviewed-by or acked-by.

Thanks,
Inki Dae

> And I asked panel vendor custom service centre also.
> 
> Thank you.
> Best regards YJ
> 
>> Thierry
>>
> 
> -- 
> To unsubscribe from this list: send the line "unsubscribe devicetree" in
> the body of a message to majordomo at vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
>