[PATCH v4 01/11] drm: sti: add bindings for DRM driver
Benjamin Gaignard
benjamin.gaignard at linaro.org
Wed May 28 23:36:57 PDT 2014
Add DRM/KMS driver bindings documentation.
Describe the required properties for each of the hardware IPs drivers.
Signed-off-by: Benjamin Gaignard <benjamin.gaignard at linaro.org>
---
.../devicetree/bindings/gpu/st,stih4xx.txt | 189 +++++++++++++++++++++
1 file changed, 189 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpu/st,stih4xx.txt
diff --git a/Documentation/devicetree/bindings/gpu/st,stih4xx.txt b/Documentation/devicetree/bindings/gpu/st,stih4xx.txt
new file mode 100644
index 0000000..59a59a7
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpu/st,stih4xx.txt
@@ -0,0 +1,189 @@
+STMicroelectronics stih4xx platforms
+
+- sti-vtg: video timing generator
+ Required properties:
+ - compatible: "st,vtg"
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ Optional properties:
+ - interrupts : VTG interrupt number to the CPU.
+ - st,slave: phandle on a slave vtg
+
+- sti-vtac: video timing advanced inter dye communication Rx and TX
+ Required properties:
+ - compatible: "st,vtac-main" or "st,vtac-aux"
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ - clocks: from common clock binding: handle hardware IP needed clocks, the
+ number of clocks may depend of the SoC type.
+ See ../clocks/clock-bindings.txt for details.
+ - clock-names: names of the clocks listed in clocks property in the same
+ order.
+
+- sti-display-subsystem: Master device for DRM sub-components
+ This device must be the parent of all the sub-components and is responsible
+ of bind them.
+ Required properties:
+ - compatible: "st,sti-display-subsystem"
+ - ranges: to allow probing of subdevices
+
+- sti-compositor: frame compositor engine
+ must be a child of sti-display-subsystem
+ Required properties:
+ - compatible: "st,stih<chip>-compositor"
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ - clocks: from common clock binding: handle hardware IP needed clocks, the
+ number of clocks may depend of the SoC type.
+ See ../clocks/clock-bindings.txt for details.
+ - clock-names: names of the clocks listed in clocks property in the same
+ order.
+ - resets: resets to be used by the device
+ See ../reset/reset.txt for details.
+ - reset-names: names of the resets listed in resets property in the same
+ order.
+ - st,vtg: phandle(s) on vtg device (main and aux) nodes.
+
+- sti-tvout: video out hardware block
+ must be a child of sti-display-subsystem
+ Required properties:
+ - compatible: "st,stih<chip>-tvout"
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ - reg-names: names of the mapped memory regions listed in regs property in
+ the same order.
+ - resets: resets to be used by the device
+ See ../reset/reset.txt for details.
+ - reset-names: names of the resets listed in resets property in the same
+ order.
+ - ranges: to allow probing of subdevices
+
+- sti-hdmi: hdmi output block
+ must be a child of sti-tvout
+ Required properties:
+ - compatible: "st,stih<chip>-hdmi";
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ - reg-names: names of the mapped memory regions listed in regs property in
+ the same order.
+ - interrupts : HDMI interrupt number to the CPU.
+ - interrupt-names: name of the interrupts listed in interrupts property in
+ the same order
+ - clocks: from common clock binding: handle hardware IP needed clocks, the
+ number of clocks may depend of the SoC type.
+ - clock-names: names of the clocks listed in clocks property in the same
+ order.
+ - hdmi,hpd-gpio: gpio id to detect if an hdmi cable is plugged or not.
+
+sti-hda:
+ Required properties:
+ must be a child of sti-tvout
+ - compatible: "st,stih<chip>-hda"
+ - reg: Physical base address of the IP registers and length of memory mapped region.
+ - reg-names: names of the mapped memory regions listed in regs property in
+ the same order.
+ - clocks: from common clock binding: handle hardware IP needed clocks, the
+ number of clocks may depend of the SoC type.
+ See ../clocks/clock-bindings.txt for details.
+ - clock-names: names of the clocks listed in clocks property in the same
+ order.
+
+Example:
+
+/ {
+ ...
+
+ vtg_main_slave: sti-vtg-main-slave at fe85A800 {
+ compatible = "st,vtg";
+ reg = <0xfe85A800 0x300>;
+ interrupts = <GIC_SPI 175 IRQ_TYPE_NONE>;
+ };
+
+ vtg_main: sti-vtg-main-master at fd348000 {
+ compatible = "st,vtg";
+ reg = <0xfd348000 0x400>;
+ st,slave = <&vtg_main_slave>;
+ };
+
+ vtg_aux_slave: sti-vtg-aux-slave at fd348400 {
+ compatible = "st,vtg";
+ reg = <0xfe858200 0x300>;
+ interrupts = <GIC_SPI 176 IRQ_TYPE_NONE>;
+ };
+
+ vtg_aux: sti-vtg-aux-master at fd348400 {
+ compatible = "st,vtg";
+ reg = <0xfd348400 0x400>;
+ st,slave = <&vtg_aux_slave>;
+ };
+
+
+ sti-vtac-rx-main at fee82800 {
+ compatible = "st,vtac-main";
+ reg = <0xfee82800 0x200>;
+ clock-names = "vtac";
+ clocks = <&CLK_M_A2_DIV0 CLK_M_VTAC_MAIN_PHY>;
+ };
+
+ sti-vtac-rx-aux at fee82a00 {
+ compatible = "st,vtac-aux";
+ reg = <0xfee82a00 0x200>;
+ clock-names = "vtac";
+ clocks = <&CLK_M_A2_DIV0 CLK_M_VTAC_AUX_PHY>;
+ };
+
+ sti-vtac-tx-main at fd349000 {
+ compatible = "st,vtac-main";
+ reg = <0xfd349000 0x200>, <0xfd320000 0x10000>;
+ clock-names = "vtac";
+ clocks = <&CLK_S_A1_HS CLK_S_VTAC_TX_PHY>;
+ };
+
+ sti-vtac-tx-aux at fd349200 {
+ compatible = "st,vtac-aux";
+ reg = <0xfd349200 0x200>, <0xfd320000 0x10000>;
+ clock-names = "vtac";
+ clocks = <&CLK_S_A1_HS CLK_S_VTAC_TX_PHY>;
+ };
+
+ sti-display-subsystem {
+ compatible = "st,sti-display-subsystem";
+ ranges;
+
+ sti-compositor at fd340000 {
+ compatible = "st,stih416-compositor";
+ reg = <0xfd340000 0x1000>;
+ clock-names = "compo_main", "compo_aux",
+ "pix_main", "pix_aux";
+ clocks = <&CLK_M_A2_DIV1 CLK_M_COMPO_MAIN>, <&CLK_M_A2_DIV1 CLK_M_COMPO_AUX>,
+ <&CLOCKGEN_C_VCC CLK_S_PIX_MAIN>, <&CLOCKGEN_C_VCC CLK_S_PIX_AUX>;
+ reset-names = "compo-main", "compo-aux";
+ resets = <&softreset STIH416_COMPO_M_SOFTRESET>, <&softreset STIH416_COMPO_A_SOFTRESET>;
+ st,vtg = <&vtg_main>, <&vtg_aux>;
+ };
+
+ sti-tvout at fe000000 {
+ compatible = "st,stih416-tvout";
+ reg = <0xfe000000 0x1000>, <0xfe85a000 0x400>, <0xfe830000 0x10000>;
+ reg-names = "tvout-reg", "hda-reg", "syscfg";
+ reset-names = "tvout";
+ resets = <&softreset STIH416_HDTVOUT_SOFTRESET>;
+ ranges;
+
+ sti-hdmi at fe85c000 {
+ compatible = "st,stih416-hdmi";
+ reg = <0xfe85c000 0x1000>, <0xfe830000 0x10000>;
+ reg-names = "hdmi-reg", "syscfg";
+ interrupts = <GIC_SPI 173 IRQ_TYPE_NONE>;
+ interrupt-names = "irq";
+ clock-names = "pix", "tmds", "phy", "audio";
+ clocks = <&CLOCKGEN_C_VCC CLK_S_PIX_HDMI>, <&CLOCKGEN_C_VCC CLK_S_TMDS_HDMI>, <&CLOCKGEN_C_VCC CLK_S_HDMI_REJECT_PLL>, <&CLOCKGEN_B1 CLK_S_PCM_0>;
+ hdmi,hpd-gpio = <&PIO2 5>;
+ };
+
+ sti-hda at fe85a000 {
+ compatible = "st,stih416-hda";
+ reg = <0xfe85a000 0x400>, <0xfe83085c 0x4>;
+ reg-names = "hda-reg", "video-dacs-ctrl";
+ clock-names = "pix", "hddac";
+ clocks = <&CLOCKGEN_C_VCC CLK_S_PIX_HD>, <&CLOCKGEN_C_VCC CLK_S_HDDAC>;
+ };
+ };
+ };
+ ...
+};
--
1.9.1
More information about the dri-devel
mailing list