[PATCH V6 0/8] drm/exynos: few patches to enhance bridge chip support

[Laurent Pinchart]

Hi Ajay,

On Wednesday 17 September 2014 15:43:04 Ajay kumar wrote:
> Hi Laurent,
> 
> Please find the latest series here:
> http://www.spinics.net/lists/dri-devel/msg66740.html

Thank you. My comment was meant to be general though, not just for your patch 
series.

> On Wed, Sep 17, 2014 at 3:23 PM, Laurent Pinchart wrote:
> > On Wednesday 30 July 2014 11:40:54 Thierry Reding wrote:

[snip]

> >> One other thing: how does the bridge know which mode to drive? I suspect
> >> that it can drive more than one mode? Can it freely be configured or
> >> does it have a predefined set of modes? If the latter, then according to
> >> what you said above there needs to be a way to configure the bridge (via
> >> DT?) so that it reports the mode matching the panel. I wonder if that
> >> should be handled completely in code, so that for example a bridge has a
> >> panel attached it can use the panel's .get_modes() and select a matching
> >> mode among the set that it supports.
> > 
> > Yes, pretty please :-) I don't think it would be a good idea to duplicate
> > mode information in the bridge DT node, as that's not a property of the
> > bridge. Querying the mode at runtime is in my opinion a much better
> > option, and would also allow switching between different modes at runtime
> > when that makes sense.
> > 
> > Now, I'm not sure whether it should be the bridge driver querying the
> > panel driver directly, or the display controller driver doing it and then
> > configuring the bridge accordingly. The latter seems more generic to me
> > and doesn't rely on the assumption that the bridge output will always be
> > directly connected to a panel.

-- 
Regards,

Laurent Pinchart