[PATCH v2 1/5] drm/rockchip: Add basic drm driver

[Daniel Vetter]

On Thu, Sep 18, 2014 at 04:52:14PM +0200, Daniel Vetter wrote:
> On Thu, Sep 18, 2014 at 05:36:31PM +0800, Mark yao wrote:
> > This patch adds the basic structure of a DRM Driver for Rockchip Socs.
> > 
> > Signed-off-by: Mark yao <mark.yao at rock-chips.com>
> > ---
> > Changes in v2:
> > - use the component framework to defer main drm driver probe
> >   until all VOP devices have been probed.
> > - use dma-mapping API with ARM_DMA_USE_IOMMU, create dma mapping by
> >   master device and each vop device can shared the drm dma mapping.
> > - use drm_crtc_init_with_planes and drm_universal_plane_init.
> > - remove unnecessary middle layers.
> > - add cursor set, move funcs to rockchip drm crtc.
> > - use vop reset at first init
> > - reference framebuffer when used and unreference when swap out vop
> > 
> 
> > +static const struct drm_crtc_funcs rockchip_crtc_funcs = {
> > +	.set_config = drm_crtc_helper_set_config,
> > +	.page_flip = rockchip_drm_crtc_page_flip,
> > +	.destroy = rockchip_drm_crtc_destroy,
> > +	.cursor_set = vop_crtc_cursor_set,
> > +	.cursor_move = vop_crtc_cursor_move,
> 
> If you expose your cursor plane as a universal you don't need to implement
> these two cursor functions at all. Actually the core never calls them, see
> drm_mode_cursor_universal. So if you want to expose cursors, please use
> universal cursor plane support (like i915).
> 
> In general that's how new drivers should expose cursors since without
> universal planes support cursors will not be supported with the atomic
> ioctl. Since your cursor code just calls the relevant plane functions that
> should even simplify your driver ;-)

Actually you already initialize with cursor universal planes, so all this
code can simply be removed.
-Daniel
-- 
Daniel Vetter
Software Engineer, Intel Corporation
+41 (0) 79 365 57 48 - http://blog.ffwll.ch