[PATCH v3 6/8] drm/rockchip: direct config connecter gate and out_mode
Mark Yao
mark.yao at rock-chips.com
Wed Dec 16 19:08:36 PST 2015
Both connecter gate and out_mode are not conflict with mode set
configure. Direct setting connecter gate and out_mode, that allow
connector do rockchip_drm_crtc_mode_config after mode set.
Signed-off-by: Mark Yao <mark.yao at rock-chips.com>
---
Changes in v3: None
Changes in v2: None
drivers/gpu/drm/rockchip/rockchip_drm_vop.c | 39 +++++++++++++--------------
1 file changed, 18 insertions(+), 21 deletions(-)
diff --git a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
index 9ace3ae..6ded4cc 100644
--- a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
+++ b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
@@ -89,9 +89,6 @@ struct vop {
struct drm_device *drm_dev;
bool is_enabled;
- int connector_type;
- int connector_out_mode;
-
/* mutex vsync_ work */
struct mutex vsync_mutex;
bool vsync_work_pending;
@@ -1018,8 +1015,24 @@ int rockchip_drm_crtc_mode_config(struct drm_crtc *crtc,
{
struct vop *vop = to_vop(crtc);
- vop->connector_type = connector_type;
- vop->connector_out_mode = out_mode;
+ if (WARN_ON(!vop->is_enabled))
+ return -EINVAL;
+
+ switch (connector_type) {
+ case DRM_MODE_CONNECTOR_LVDS:
+ VOP_CTRL_SET(vop, rgb_en, 1);
+ break;
+ case DRM_MODE_CONNECTOR_eDP:
+ VOP_CTRL_SET(vop, edp_en, 1);
+ break;
+ case DRM_MODE_CONNECTOR_HDMIA:
+ VOP_CTRL_SET(vop, hdmi_en, 1);
+ break;
+ default:
+ DRM_ERROR("unsupport connector_type[%d]\n", connector_type);
+ return -EINVAL;
+ };
+ VOP_CTRL_SET(vop, out_mode, out_mode);
return 0;
}
@@ -1132,22 +1145,6 @@ static void vop_crtc_enable(struct drm_crtc *crtc)
vop_dsp_hold_valid_irq_disable(vop);
}
- switch (vop->connector_type) {
- case DRM_MODE_CONNECTOR_LVDS:
- VOP_CTRL_SET(vop, rgb_en, 1);
- break;
- case DRM_MODE_CONNECTOR_eDP:
- VOP_CTRL_SET(vop, edp_en, 1);
- break;
- case DRM_MODE_CONNECTOR_HDMIA:
- VOP_CTRL_SET(vop, hdmi_en, 1);
- break;
- default:
- DRM_ERROR("unsupport connector_type[%d]\n",
- vop->connector_type);
- };
- VOP_CTRL_SET(vop, out_mode, vop->connector_out_mode);
-
val = 0x8;
val |= (adjusted_mode->flags & DRM_MODE_FLAG_NHSYNC) ? 0 : 1;
val |= (adjusted_mode->flags & DRM_MODE_FLAG_NVSYNC) ? 0 : (1 << 1);
--
1.7.9.5
More information about the dri-devel
mailing list