[PATCH v2] drm/dp: add DPCD definitions from eDP 1.4

Jindal, Sonika sonika.jindal at intel.com
Fri Feb 27 05:46:33 PST 2015


Reviewed-by: Sonika Jindal <sonika.jindal at intel.com>

On 2/27/2015 4:41 PM, Jani Nikula wrote:
> Add a number of DPCD definitions from eDP 1.4.
>
> v2: s/DP_ALPM_LOCK_TIMEOUT_ERROR_STATUS/DP_ALPM_LOCK_TIMEOUT_ERROR/
>     (Sonika)
>
> Signed-off-by: Jani Nikula <jani.nikula at intel.com>
> ---
>   include/drm/drm_dp_helper.h | 37 +++++++++++++++++++++++++++++++++++++
>   1 file changed, 37 insertions(+)
>
> diff --git a/include/drm/drm_dp_helper.h b/include/drm/drm_dp_helper.h
> index 319d5edfb3b5..c5fdc2d3ca97 100644
> --- a/include/drm/drm_dp_helper.h
> +++ b/include/drm/drm_dp_helper.h
> @@ -168,10 +168,18 @@
>   #define DP_AUD_DEL_INS2			    0x02d
>   /* End of AV_SYNC_DATA_BLOCK */
>
> +#define DP_RECEIVER_ALPM_CAP		    0x02e   /* eDP 1.4 */
> +# define DP_ALPM_CAP			    (1 << 0)
> +
> +#define DP_SINK_DEVICE_AUX_FRAME_SYNC_CAP   0x02f   /* eDP 1.4 */
> +# define DP_AUX_FRAME_SYNC_CAP		    (1 << 0)
> +
>   #define DP_GUID				    0x030   /* 1.2 */
>
>   #define DP_PSR_SUPPORT                      0x070   /* XXX 1.2? */
>   # define DP_PSR_IS_SUPPORTED                1
> +# define DP_PSR2_IS_SUPPORTED		    2	    /* eDP 1.4 */
> +
>   #define DP_PSR_CAPS                         0x071   /* XXX 1.2? */
>   # define DP_PSR_NO_TRAIN_ON_EXIT            1
>   # define DP_PSR_SETUP_TIME_330              (0 << 1)
> @@ -211,6 +219,7 @@
>
>   /* link configuration */
>   #define	DP_LINK_BW_SET		            0x100
> +# define DP_LINK_RATE_TABLE		    0x00    /* eDP 1.4 */
>   # define DP_LINK_BW_1_62		    0x06
>   # define DP_LINK_BW_2_7			    0x0a
>   # define DP_LINK_BW_5_4			    0x14    /* 1.2 */
> @@ -307,15 +316,30 @@
>   #define DP_AUDIO_DELAY2			    0x114
>
>   #define DP_LINK_RATE_SET		    0x115   /* eDP 1.4 */
> +# define DP_LINK_RATE_SET_SHIFT		    0
> +# define DP_LINK_RATE_SET_MASK		    (7 << 0)
> +
> +#define DP_RECEIVER_ALPM_CONFIG		    0x116   /* eDP 1.4 */
> +# define DP_ALPM_ENABLE			    (1 << 0)
> +# define DP_ALPM_LOCK_ERROR_IRQ_HPD_ENABLE  (1 << 1)
> +
> +#define DP_SINK_DEVICE_AUX_FRAME_SYNC_CONF  0x117   /* eDP 1.4 */
> +# define DP_AUX_FRAME_SYNC_ENABLE	    (1 << 0)
> +# define DP_IRQ_HPD_ENABLE		    (1 << 1)
>
>   #define DP_UPSTREAM_DEVICE_DP_PWR_NEED	    0x118   /* 1.2 */
>   # define DP_PWR_NOT_NEEDED		    (1 << 0)
>
> +#define DP_AUX_FRAME_SYNC_VALUE		    0x15c   /* eDP 1.4 */
> +# define DP_AUX_FRAME_SYNC_VALID	    (1 << 0)
> +
>   #define DP_PSR_EN_CFG			    0x170   /* XXX 1.2? */
>   # define DP_PSR_ENABLE			    (1 << 0)
>   # define DP_PSR_MAIN_LINK_ACTIVE	    (1 << 1)
>   # define DP_PSR_CRC_VERIFICATION	    (1 << 2)
>   # define DP_PSR_FRAME_CAPTURE		    (1 << 3)
> +# define DP_PSR_SELECTIVE_UPDATE	    (1 << 4)
> +# define DP_PSR_IRQ_HPD_WITH_CRC_ERRORS     (1 << 5)
>
>   #define DP_ADAPTER_CTRL			    0x1a0
>   # define DP_ADAPTER_CTRL_FORCE_LOAD_SENSE   (1 << 0)
> @@ -423,6 +447,10 @@
>   # define DP_SET_POWER_MASK                  0x3
>
>   #define DP_EDP_DPCD_REV			    0x700    /* eDP 1.2 */
> +# define DP_EDP_11			    0x00
> +# define DP_EDP_12			    0x01
> +# define DP_EDP_13			    0x02
> +# define DP_EDP_14			    0x03
>
>   #define DP_EDP_GENERAL_CAP_1		    0x701
>
> @@ -430,6 +458,8 @@
>
>   #define DP_EDP_GENERAL_CAP_2		    0x703
>
> +#define DP_EDP_GENERAL_CAP_3		    0x704    /* eDP 1.4 */
> +
>   #define DP_EDP_DISPLAY_CONTROL_REGISTER     0x720
>
>   #define DP_EDP_BACKLIGHT_MODE_SET_REGISTER  0x721
> @@ -456,6 +486,9 @@
>   #define DP_EDP_DBC_MINIMUM_BRIGHTNESS_SET   0x732
>   #define DP_EDP_DBC_MAXIMUM_BRIGHTNESS_SET   0x733
>
> +#define DP_EDP_REGIONAL_BACKLIGHT_BASE      0x740    /* eDP 1.4 */
> +#define DP_EDP_REGIONAL_BACKLIGHT_0	    0x741    /* eDP 1.4 */
> +
>   #define DP_SIDEBAND_MSG_DOWN_REQ_BASE	    0x1000   /* 1.2 MST */
>   #define DP_SIDEBAND_MSG_UP_REP_BASE	    0x1200   /* 1.2 MST */
>   #define DP_SIDEBAND_MSG_DOWN_REP_BASE	    0x1400   /* 1.2 MST */
> @@ -474,6 +507,7 @@
>   #define DP_PSR_ERROR_STATUS                 0x2006  /* XXX 1.2? */
>   # define DP_PSR_LINK_CRC_ERROR              (1 << 0)
>   # define DP_PSR_RFB_STORAGE_ERROR           (1 << 1)
> +# define DP_PSR_VSC_SDP_UNCORRECTABLE_ERROR (1 << 2) /* eDP 1.4 */
>
>   #define DP_PSR_ESI                          0x2007  /* XXX 1.2? */
>   # define DP_PSR_CAPS_CHANGE                 (1 << 0)
> @@ -487,6 +521,9 @@
>   # define DP_PSR_SINK_INTERNAL_ERROR         7
>   # define DP_PSR_SINK_STATE_MASK             0x07
>
> +#define DP_RECEIVER_ALPM_STATUS		    0x200b  /* eDP 1.4 */
> +# define DP_ALPM_LOCK_TIMEOUT_ERROR	    (1 << 0)
> +
>   /* DP 1.2 Sideband message defines */
>   /* peer device type - DP 1.2a Table 2-92 */
>   #define DP_PEER_DEVICE_NONE		0x0
>


More information about the dri-devel mailing list