[PATCH 09/10] dt-bindings: video: exynos5433-decon: add bindings for DECON-TV

[Krzysztof Kozlowski]

2015-10-20 21:53 GMT+09:00 Andrzej Hajda <a.hajda at samsung.com>:
> On 10/20/2015 02:30 PM, Krzysztof Kozlowski wrote:
>> W dniu 20.10.2015 o 18:22, Andrzej Hajda pisze:
>>> DECON-TV(Display and Enhancement Controller for TV) is a variation
>>> of DECON IP. Its main purpose is to produce video stream for HDMI IP.
>>>
>>> Signed-off-by: Andrzej Hajda <a.hajda at samsung.com>
>>> ---
>>>  .../devicetree/bindings/video/exynos5433-decon.txt  | 21 ++++++++++++---------
>>>  1 file changed, 12 insertions(+), 9 deletions(-)
>>>
>>> diff --git a/Documentation/devicetree/bindings/video/exynos5433-decon.txt b/Documentation/devicetree/bindings/video/exynos5433-decon.txt
>>> index 3dff78b..2a88c8d 100644
>>> --- a/Documentation/devicetree/bindings/video/exynos5433-decon.txt
>>> +++ b/Documentation/devicetree/bindings/video/exynos5433-decon.txt
>>> @@ -5,24 +5,27 @@ Exynos series of SoCs which transfers the image data from a video memory
>>>  buffer to an external LCD interface.
>>>
>>>  Required properties:
>>> -- compatible: value should be "samsung,exynos5433-decon";
>>> +- compatible: value should be one of:
>>> +    "samsung,exynos5433-decon", "samsung,exynos5433-decon-tv";
>> Until this point it looked good.
>>
>>>  - reg: physical base address and length of the DECON registers set.
>>> -- interrupts: should contain a list of all DECON IP block interrupts in the
>>> -          order: VSYNC, LCD_SYSTEM. The interrupt specifier format
>>> -          depends on the interrupt controller used.
>>> -- interrupt-names: should contain the interrupt names: "vsync", "lcd_sys"
>>> -               in the same order as they were listed in the interrupts
>>> -               property.
>>> +- interrupts: should contain interrupt specifier of VSYNC and optionally
>>> +          LCD_SYSTEM. The interrupt specifier format depends on
>>> +          the interrupt controller used.
>>> +- interrupt-names: should contain the interrupt name "vsync" and optionally
>>> +               "lcd_sys" in the same order as they were listed in
>>> +               the interrupts property.
>> The driver already did not require both interrupts, right? Only one of them?
>
> Right. More precisely it did not require since beginning.

So can you move it to the cleanup patch with change below?

Best regards,
Krzysztof