[PATCH] drm/rockchip: vop: Correct enabled clocks during setup
Yakir Yang
ykk at rock-chips.com
Tue Sep 29 03:58:07 PDT 2015
On 09/29/2015 05:55 PM, Yakir Yang wrote:
>
>
> On 09/29/2015 05:28 PM, Sjoerd Simons wrote:
>> When doing the initial setup both the hclk and the aclk need to be
>> enabled otherwise the board will simply hang. This only occurs when
>> building the vop driver as a module, when its built-in the initial setup
Hmm... My previous test was built-in the vop driver, and just notice that
you say problem only occurred when building the vop driver as module.
That's to say my test was wrong, so I try to do the right things.
But I found that vop driver module and rockchipdrm driver module in
dependency cycles, here are the build message:
depmod: ERROR: Found 2 modules in dependency cycles!
depmod: ERROR: Cycle detected: rockchip_drm_vop -> rockchipdrm ->
rockchip_drm_vop
Makefile:1054: recipe for target '_modinst_post' failed
And past my Makefile:
vop-y := rockchip_drm_drv.o rockchip_drm_fb.o rockchip_drm_fbdev.o
rockchip_drm_gem.o
obj-m = rockchip_drm_vop.o vop.o
Very like to know how you handle this dependency cycles :)
Thanks,
- Yakir
>> happens to run before the clock framework shuts of unused clocks
>> (including the aclk).
>>
>> While there also switch to doing prepare and enable in one step rather
>> then separate steps to reduce the amount of code required.
>>
>> Signed-off-by: Sjoerd Simons <sjoerd.simons at collabora.co.uk>
>
> Looks good and test on chromeos-3.14 tree, no problem, so
>
> Tested-by: Yakir Yang <ykk at rock-chips.com>
>
>> ---
>>
>> drivers/gpu/drm/rockchip/rockchip_drm_vop.c | 36
>> +++++++++++------------------
>> 1 file changed, 14 insertions(+), 22 deletions(-)
>>
>> diff --git a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
>> b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
>> index 5d8ae5e..48719df 100644
>> --- a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
>> +++ b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
>> @@ -1575,32 +1575,25 @@ static int vop_initial(struct vop *vop)
>> return PTR_ERR(vop->dclk);
>> }
>> - ret = clk_prepare(vop->hclk);
>> - if (ret < 0) {
>> - dev_err(vop->dev, "failed to prepare hclk\n");
>> - return ret;
>> - }
>> -
>> ret = clk_prepare(vop->dclk);
>> if (ret < 0) {
>> dev_err(vop->dev, "failed to prepare dclk\n");
>> - goto err_unprepare_hclk;
>> + return ret;
>> }
>> - ret = clk_prepare(vop->aclk);
>> + /* Enable both the hclk and aclk to setup the vop */
>> + ret = clk_prepare_enable(vop->hclk);
>> if (ret < 0) {
>> - dev_err(vop->dev, "failed to prepare aclk\n");
>> + dev_err(vop->dev, "failed to prepare/enable hclk\n");
>> goto err_unprepare_dclk;
>> }
>> - /*
>> - * enable hclk, so that we can config vop register.
>> - */
>> - ret = clk_enable(vop->hclk);
>> + ret = clk_prepare_enable(vop->aclk);
>> if (ret < 0) {
>> - dev_err(vop->dev, "failed to prepare aclk\n");
>> - goto err_unprepare_aclk;
>> + dev_err(vop->dev, "failed to prepare/enable aclk\n");
>> + goto err_disable_hclk;
>> }
>> +
>> /*
>> * do hclk_reset, reset all vop registers.
>> */
>> @@ -1608,7 +1601,7 @@ static int vop_initial(struct vop *vop)
>> if (IS_ERR(ahb_rst)) {
>> dev_err(vop->dev, "failed to get ahb reset\n");
>> ret = PTR_ERR(ahb_rst);
>> - goto err_disable_hclk;
>> + goto err_disable_aclk;
>> }
>> reset_control_assert(ahb_rst);
>> usleep_range(10, 20);
>> @@ -1634,26 +1627,25 @@ static int vop_initial(struct vop *vop)
>> if (IS_ERR(vop->dclk_rst)) {
>> dev_err(vop->dev, "failed to get dclk reset\n");
>> ret = PTR_ERR(vop->dclk_rst);
>> - goto err_unprepare_aclk;
>> + goto err_disable_aclk;
>> }
>> reset_control_assert(vop->dclk_rst);
>> usleep_range(10, 20);
>> reset_control_deassert(vop->dclk_rst);
>> clk_disable(vop->hclk);
>> + clk_disable(vop->aclk);
>> vop->is_enabled = false;
>> return 0;
>> +err_disable_aclk:
>> + clk_disable_unprepare(vop->aclk);
>> err_disable_hclk:
>> - clk_disable(vop->hclk);
>> -err_unprepare_aclk:
>> - clk_unprepare(vop->aclk);
>> + clk_disable_unprepare(vop->hclk);
>> err_unprepare_dclk:
>> clk_unprepare(vop->dclk);
>> -err_unprepare_hclk:
>> - clk_unprepare(vop->hclk);
>> return ret;
>> }
>
More information about the dri-devel
mailing list