[Intel-gfx] [PATCH 3/5] drm/crtc: take references to connectors used in a modeset.
Daniel Vetter
daniel at ffwll.ch
Wed Apr 27 07:48:02 UTC 2016
On Wed, Apr 27, 2016 at 09:34:34AM +0200, Daniel Vetter wrote:
> On Wed, Apr 27, 2016 at 12:03:27PM +1000, Dave Airlie wrote:
> > From: Dave Airlie <airlied at redhat.com>
> >
> > This just takes a reference on the connector when we set a mode
> > in the non-atomic paths.
> >
> > Signed-off-by: Dave Airlie <airlied at redhat.com>
>
> Reviewed-by: Daniel Vetter <daniel.vetter at ffwll.ch>
Ok I feel real silly now reading Daniel Stone's reply ;-) r-b retracted
...
Cheers, Daniel
>
> > ---
> > drivers/gpu/drm/drm_crtc_helper.c | 6 ++++++
> > 1 file changed, 6 insertions(+)
> >
> > diff --git a/drivers/gpu/drm/drm_crtc_helper.c b/drivers/gpu/drm/drm_crtc_helper.c
> > index 66ca313..29b7835 100644
> > --- a/drivers/gpu/drm/drm_crtc_helper.c
> > +++ b/drivers/gpu/drm/drm_crtc_helper.c
> > @@ -456,6 +456,9 @@ drm_crtc_helper_disable(struct drm_crtc *crtc)
> > * between them is henceforth no longer available.
> > */
> > connector->dpms = DRM_MODE_DPMS_OFF;
> > +
> > + /* we keep a reference while the encoder is bound */
> > + drm_connector_unreference(connector);
> > }
> > }
> >
> > @@ -635,9 +638,12 @@ int drm_crtc_helper_set_config(struct drm_mode_set *set)
> > mode_changed = true;
> > /* If the encoder is reused for another connector, then
> > * the appropriate crtc will be set later.
> > + * take a reference only if we haven't had an encoder before.
> > */
> > if (connector->encoder)
> > connector->encoder->crtc = NULL;
> > + else
> > + drm_connector_reference(connector);
> > connector->encoder = new_encoder;
> > }
> > }
> > --
> > 2.5.5
> >
> > _______________________________________________
> > Intel-gfx mailing list
> > Intel-gfx at lists.freedesktop.org
> > https://lists.freedesktop.org/mailman/listinfo/intel-gfx
>
> --
> Daniel Vetter
> Software Engineer, Intel Corporation
> http://blog.ffwll.ch
--
Daniel Vetter
Software Engineer, Intel Corporation
http://blog.ffwll.ch
More information about the dri-devel
mailing list