[PATCH 0/3] drm/tilcdc: Some fixes for LCDC rev1

[Karl Beldan]

Hi,

I found some missing bits for rev1 of the LCDC and here are some of the
changes I am using to use the DRM driver on an LCDCK (which has a rev1).
1/3 seems required by rev1 of the IP and without it my the LCDC on my
LCDK keeps can't sync, 2/3 is required by the driver logic, while 3/3
is less of a requirement.
Although 1,2/3 would have fitted drm-fixes I based them on drm-next as
2/3 would conflict with the recent changes in drm-next.

Another thing which is also an absolute requirement for the rev1 but 
with which rev2 seems to cope fine is the palette loading (even if the DRM
uses >= 16bpp formats), dixit the TRM:
"12-, 16-, and 24-BPP modes do not need a palette; i.e., the pixel data is
the desired RGB value. However, the first 32 bytes are still considered a
palette. The first entry should be 4000h (bit 14 is 1) while the remaining
entries must be filled with 0.".
ATM I am using a local crude way of loading the palette to verify the
missing bits to get the DRM driver properly working on the LCDK (as I
haven't seen how things work in the DRM subsystem I can't post any proper
change for that).

The posted changes and the above mentioned palette loading missing bit 
are specific to the DRM driver.

However there are other shortcomings to the proper functioning of the 
LCDC on some platforms (I am currently focusing on the LCDK but I guess 
it should be true for all da850 based systems), which are not inherent to
the DRM driver driver but which strongly relate to it:

- The pixel clock rate setting (eg. currently the davinci clk can't cope
properly with the DRM driver way of setting the clock and doesn't use
the common clock framework)
- The memory bandwidth/latency requirements for the LCDC are not met 
with the default priority settings (apparently there is a fix in
da850_lcd_hw_init of: http://arago-project.org/git/projects/linux-davinci.git?p=projects/linux-davinci.git;a=blob;f=arch/arm/mach-davinci/board-omapl138-lcdk.c;h=689b4f304011e09e262782cf8c4b96eba00ac28b;hb=HEAD).
Of course this one affects both the DRM and framebuffer systems.

Hence to test the LCDK my crude local changes include (ie. on top of the
posted changes and some dts or sync_lost recovery bits):
- palette loading
- tweak of the pixel clock to cope with davinci clk
- adjustment of the memory master priorities


BTW, with the recent changes of tilcdc from drm-next, I see this warning
when loading the module:
"drm:drm_helper_disable_unused_functions [drm_kms_helper]] *ERROR* Called for atomic driver, this is not what you want."


Regards, 
Karl


Karl Beldan (3):
  drm/tilcdc: Adjust the FB_CEILING address
  drm/tilcdc: Enable EOF interrupts for v1 LCDC
  drm/tilcdc: Advertise the DRM_FORMATs according to the IP revision

 drivers/gpu/drm/tilcdc/tilcdc_crtc.c  | 4 +++-
 drivers/gpu/drm/tilcdc/tilcdc_plane.c | 7 ++++++-
 2 files changed, 9 insertions(+), 2 deletions(-)

-- 
2.9.2