[PATCH 08/18] drm/i915/dsi: Document the panel enable / disable sequences from the spec

[Jani Nikula]

On Thu, 01 Dec 2016, Hans de Goede <hdegoede at redhat.com> wrote:
> Document the DSI panel enable / disable sequences from the spec,
> for easy comparison between the code and the spec.
>
> Signed-off-by: Hans de Goede <hdegoede at redhat.com>

I haven't done a proper review, but patches 1-8 are

Acked-by: Jani Nikula <jani.nikula at intel.com>

> ---
>  drivers/gpu/drm/i915/intel_dsi.c | 64 ++++++++++++++++++++++++++++++++++++++++
>  1 file changed, 64 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/intel_dsi.c b/drivers/gpu/drm/i915/intel_dsi.c
> index 2222229..85b748d 100644
> --- a/drivers/gpu/drm/i915/intel_dsi.c
> +++ b/drivers/gpu/drm/i915/intel_dsi.c
> @@ -555,6 +555,70 @@ static void intel_dsi_prepare(struct intel_encoder *intel_encoder,
>  			      struct intel_crtc_state *pipe_config);
>  static void intel_dsi_unprepare(struct intel_encoder *encoder);
>  
> +/*
> + * Panel enable/disable sequences from the spec:
> + *
> + * v2 sequence for video mode:
> + * - power on
> + * - wait t1+t2
> + * - MIPIDeassertResetPin
> + * - clk/data lines to lp-11
> + * - MIPISendInitialDcsCmds
> + * - turn on DPI
> + * - MIPIDisplayOn
> + * - wait t5
> + * - backlight on
> + * ...
> + * - backlight off
> + * - wait t6
> + * - MIPIDisplayOff
> + * - turn off DPI
> + * - clk/data lines to lp-00
> + * - MIPIAssertResetPin
> + * - wait t3
> + * - power off
> + * - wait t4
> + *
> + * v3 sequence for video mode:
> + * - MIPIPanelPowerOn
> + * - MIPIDeassertResetPin
> + * - set clk/data lines to lp-11
> + * - MIPISendInitialDcsCmds (LP)
> + * - turn on DPI
> + * - MIPITearOn (command mode only) + MIPIDisplayOn (LP and HS)
> + * - MIPIBacklightOn
> + * ...
> + * - MIPIBacklightOff
> + * - turn off DPI
> + * - MIPITearOff + MIPIDisplayOff (LP)
> + * - clk/data lines to lp-00
> + * - MIPIAssertResetPin
> + * - MIPIPanelPowerOff
> + *
> + * sequence for command mode:
> + * - power on
> + * - wait t1+t2
> + * - MIPIDeassertResetPin
> + * - clk/data lines to lp-11
> + * - MIPISendInitialDcsCmds
> + * - MIPITearOn
> + * - MIPIDisplayOn
> + * - set pipe to dsr mode
> + * - wait t5
> + * - backlight on
> + * ... issue write_mem_start/write_mem_continue commands ...
> + * - backlight off
> + * - wait t6
> + * - disable pipe dsr mode
> + * - MIPITearOff
> + * - MIPIDisplayOff
> + * - clk/data lines to lp-00
> + * - MIPIAssertResetPin
> + * - wait t3
> + * - power off
> + * - wait t4
> + */
> +
>  static void intel_dsi_pre_enable(struct intel_encoder *encoder,
>  				 struct intel_crtc_state *pipe_config,
>  				 struct drm_connector_state *conn_state)

-- 
Jani Nikula, Intel Open Source Technology Center