[PATCH 03/21] drm/tilcdc: verify fb pitch
Jyri Sarha
jsarha at ti.com
Thu Feb 4 09:30:56 UTC 2016
From: Tomi Valkeinen <tomi.valkeinen at ti.com>
LCDC hardware does not support fb pitch that is different (i.e. larger)
than the screen size. The driver currently does no checks for this, and
the results of too big pitch are are flickering and lower fps.
This issue easily happens when using libdrm's modetest tool with non-32
bpp modes. As modetest always allocated 4 bytes per pixel, it implies a
bigger pitch for 16 or 24 bpp modes.
This patch adds a check to reject pitches the hardware cannot support.
Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>
Signed-off-by: Darren Etheridge <detheridge at ti.com>
Signed-off-by: Jyri Sarha <jsarha at ti.com>
---
drivers/gpu/drm/tilcdc/tilcdc_crtc.c | 31 +++++++++++++++++++++++++++++++
1 file changed, 31 insertions(+)
diff --git a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
index 7b687ae..105f286 100644
--- a/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
+++ b/drivers/gpu/drm/tilcdc/tilcdc_crtc.c
@@ -151,6 +151,22 @@ static void tilcdc_crtc_destroy(struct drm_crtc *crtc)
kfree(tilcdc_crtc);
}
+static int tilcdc_verify_fb(struct drm_crtc *crtc, struct drm_framebuffer *fb)
+{
+ struct drm_device *dev = crtc->dev;
+ unsigned int depth, bpp;
+
+ drm_fb_get_bpp_depth(fb->pixel_format, &depth, &bpp);
+
+ if (fb->pitches[0] != crtc->mode.hdisplay * bpp / 8) {
+ dev_err(dev->dev,
+ "Invalid pitch: fb and crtc widths must be the same");
+ return -EINVAL;
+ }
+
+ return 0;
+}
+
static int tilcdc_crtc_page_flip(struct drm_crtc *crtc,
struct drm_framebuffer *fb,
struct drm_pending_vblank_event *event,
@@ -158,6 +174,11 @@ static int tilcdc_crtc_page_flip(struct drm_crtc *crtc,
{
struct tilcdc_crtc *tilcdc_crtc = to_tilcdc_crtc(crtc);
struct drm_device *dev = crtc->dev;
+ int r;
+
+ r = tilcdc_verify_fb(crtc, fb);
+ if (r)
+ return r;
if (tilcdc_crtc->event) {
dev_err(dev->dev, "already pending page flip!\n");
@@ -272,6 +293,10 @@ static int tilcdc_crtc_mode_set(struct drm_crtc *crtc,
if (WARN_ON(!info))
return -EINVAL;
+ ret = tilcdc_verify_fb(crtc, crtc->primary->fb);
+ if (ret)
+ return ret;
+
pm_runtime_get_sync(dev->dev);
/* Configure the Burst Size and fifo threshold of DMA: */
@@ -431,6 +456,12 @@ static int tilcdc_crtc_mode_set(struct drm_crtc *crtc,
static int tilcdc_crtc_mode_set_base(struct drm_crtc *crtc, int x, int y,
struct drm_framebuffer *old_fb)
{
+ int r;
+
+ r = tilcdc_verify_fb(crtc, crtc->primary->fb);
+ if (r)
+ return r;
+
update_scanout(crtc);
return 0;
}
--
1.9.1
More information about the dri-devel
mailing list