[PATCH v2 05/21] drm/tilcdc: make frame_done interrupt active at all times

Jyri Sarha jsarha at ti.com
Tue Feb 16 14:18:22 UTC 2016


From: Darren Etheridge <detheridge at ti.com>

The frame_done interrupt was only being enabled when the vsync
interrupts were being enabled by DRM.  However the frame_done is
used to determine if the LCD controller has successfully completed
the raster_enable, raster_disable commands and the vsync interrupts
are not always enabled during these operations.

Signed-off-by: Darren Etheridge <detheridge at ti.com>
Tested-by: Dave Gerlach <d-gerlach at ti.com>
Signed-off-by: Jyri Sarha <jsarha at ti.com>
---
 drivers/gpu/drm/tilcdc/tilcdc_drv.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/tilcdc/tilcdc_drv.c b/drivers/gpu/drm/tilcdc/tilcdc_drv.c
index d7b60b4..41720ad 100644
--- a/drivers/gpu/drm/tilcdc/tilcdc_drv.c
+++ b/drivers/gpu/drm/tilcdc/tilcdc_drv.c
@@ -376,7 +376,9 @@ static int tilcdc_irq_postinstall(struct drm_device *dev)
 	if (priv->rev == 1)
 		tilcdc_set(dev, LCDC_RASTER_CTRL_REG, LCDC_V1_UNDERFLOW_INT_ENA);
 	else
-		tilcdc_set(dev, LCDC_INT_ENABLE_SET_REG, LCDC_V2_UNDERFLOW_INT_ENA);
+		tilcdc_set(dev, LCDC_INT_ENABLE_SET_REG,
+			   LCDC_V2_UNDERFLOW_INT_ENA |
+			   LCDC_FRAME_DONE);
 
 	return 0;
 }
@@ -410,7 +412,7 @@ static void enable_vblank(struct drm_device *dev, bool enable)
 	} else {
 		reg = LCDC_INT_ENABLE_SET_REG;
 		mask = LCDC_V2_END_OF_FRAME0_INT_ENA |
-			LCDC_V2_END_OF_FRAME1_INT_ENA | LCDC_FRAME_DONE;
+			LCDC_V2_END_OF_FRAME1_INT_ENA;
 	}
 
 	if (enable)
-- 
1.9.1



More information about the dri-devel mailing list