[PATCH 13/13] dt/bindings: drm/msm/hdmi: Add hdmi phy bindings

[Rob Herring]

On Thu, Jan 21, 2016 at 12:39:41PM +0530, Archit Taneja wrote:
> Add hdmi phy bindings. Update the example to use hdmi phy.
> 
> Add a missing power-domains property in the hdmi core bindings.
> 
> Cc: devicetree at vger.kernel.org
> Cc: Rob Herring <robh at kernel.org>
> 
> Signed-off-by: Archit Taneja <architt at codeaurora.org>
> ---
>  .../devicetree/bindings/display/msm/hdmi.txt       | 39 +++++++++++++++++++++-
>  1 file changed, 38 insertions(+), 1 deletion(-)
> 
> diff --git a/Documentation/devicetree/bindings/display/msm/hdmi.txt b/Documentation/devicetree/bindings/display/msm/hdmi.txt
> index 379ee2e..21590ee 100644
> --- a/Documentation/devicetree/bindings/display/msm/hdmi.txt
> +++ b/Documentation/devicetree/bindings/display/msm/hdmi.txt
> @@ -11,6 +11,7 @@ Required properties:
>  - reg: Physical base address and length of the controller's registers
>  - reg-names: "core_physical"
>  - interrupts: The interrupt signal from the hdmi block.
> +- power-domains: Should be <&mmcc MDSS_GDSC>.
>  - clocks: device clocks
>    See ../clocks/clock-bindings.txt for details.
>  - qcom,hdmi-tx-ddc-clk-gpio: ddc clk pin
> @@ -18,6 +19,7 @@ Required properties:
>  - qcom,hdmi-tx-hpd-gpio: hpd pin
>  - core-vdda-supply: phandle to supply regulator
>  - hdmi-mux-supply: phandle to mux regulator
> +- qcom,dsi-phy: phandle to HDMI PHY device node

dsi?

Why does this not use the phy binding?

Rob