[PATCH v3 4/6] drm/panel: simple: Add support for Samsung LSN122DL01-C01 2560x1600 panel

[Yakir Yang]

Doug,

On 06/14/2016 01:00 AM, Doug Anderson wrote:
> Yakir,
>
> On Sat, Jun 11, 2016 at 7:56 PM, Yakir Yang <ykk at rock-chips.com> wrote:
>> The Samsung LSN122DL01-C01 is an 12.2" 2560x1600 (WQXGA) TFT-LCD panel
>> connected using eDP interfaces.
>>
>> Signed-off-by: Yakir Yang <ykk at rock-chips.com>
>> ---
>> Changes in v3:
>> - Correct the size of panel_desc to active area 262mmx164mm (Emil, Stéphane)
>>
>> Changes in v2: None
>>
>>   drivers/gpu/drm/panel/panel-simple.c | 25 +++++++++++++++++++++++++
>>   1 file changed, 25 insertions(+)
>>
>> diff --git a/drivers/gpu/drm/panel/panel-simple.c b/drivers/gpu/drm/panel/panel-simple.c
>> index 2d40a21..17cc973 100644
>> --- a/drivers/gpu/drm/panel/panel-simple.c
>> +++ b/drivers/gpu/drm/panel/panel-simple.c
>> @@ -1246,6 +1246,28 @@ static const struct panel_desc qd43003c0_40 = {
>>          .bus_format = MEDIA_BUS_FMT_RGB888_1X24,
>>   };
>>
>> +static const struct drm_display_mode samsung_lsn122dl01_c01_mode = {
>> +       .clock = 271560,
>> +       .hdisplay = 2560,
>> +       .hsync_start = 2560 + 48,
>> +       .hsync_end = 2560 + 48 + 32,
>> +       .htotal = 2560 + 48 + 32 + 80,
>> +       .vdisplay = 1600,
>> +       .vsync_start = 1600 + 2,
>> +       .vsync_end = 1600 + 2 + 5,
>> +       .vtotal = 1600 + 2 + 5 + 57,
>> +       .vrefresh = 60,
>> +};
>> +
>> +static const struct panel_desc samsung_lsn122dl01_c01 = {
>> +       .modes = &samsung_lsn122dl01_c01_mode,
>> +       .num_modes = 1,
>> +       .size = {
>> +               .width = 262,
>> +               .height = 164,
> Earlier you said that the active area of this panel was:
>
>> Display area     262.656(H) X 164.16(V)         (12.2”diagonal)
> In other panels I looked at the EDID tended to round numbers, not
> truncate them.  For instance the Starry panel that I sent the patch
> for says in the manual "262.7712 (H) x 164.232 (V)" but then the EDID
> says "263 x 164".

Ah, got it, done.

Thanks,
- Yakir

> That would mean your width should be 263 mm, not 262 mm.
>
> -Doug
>
>
>