[PATCH] drm/i915/vlv: Enable/disable VGA hotplugging properly

[Lyude]

On Valleyview, VGA hotplugging is controlled through a seperate register
than everything else, VLV_ADPA, which must be explicitly set.

While VGA hotplugging worked(ish) before, it looks like that was mainly
because we'd unintentionally enable it in
valleyview_crt_detect_hotplug() when we did a force trigger. This
doesn't work reliably enough because whenever the display powerwell on
vlv gets disabled, the values set in VLV_ADPA get cleared and
consequently VGA hotplugging gets disabled. This causes bugs such as one
we found on an Intel NUC, where doing the following sequence of
hotplugs:

	- Disconnect all monitors
	- Connect VGA
	- Disconnect VGA
	- Connect HDMI

Would result in hotplugging getting disabled, due to the display
powerwells getting toggled in the process of connecting HDMI.

CC: stable at vger.kernel.org
Signed-off-by: Lyude <cpaul at redhat.com>
---
 drivers/gpu/drm/i915/i915_irq.c | 14 ++++++++++++++
 1 file changed, 14 insertions(+)

diff --git a/drivers/gpu/drm/i915/i915_irq.c b/drivers/gpu/drm/i915/i915_irq.c
index 5aa4239..60592a4 100644
--- a/drivers/gpu/drm/i915/i915_irq.c
+++ b/drivers/gpu/drm/i915/i915_irq.c
@@ -3611,6 +3611,7 @@ static void valleyview_display_irqs_install(struct drm_i915_private *dev_priv)
 {
 	u32 pipestat_mask;
 	u32 iir_mask;
+	u32 adpa_reg;
 	enum pipe pipe;
 
 	pipestat_mask = PIPESTAT_INT_STATUS_MASK |
@@ -3627,6 +3628,12 @@ static void valleyview_display_irqs_install(struct drm_i915_private *dev_priv)
 	for_each_pipe(dev_priv, pipe)
 		      i915_enable_pipestat(dev_priv, pipe, pipestat_mask);
 
+	if (IS_VALLEYVIEW(dev_priv)) {
+		adpa_reg = I915_READ(VLV_ADPA);
+		adpa_reg |= ADPA_CRT_HOTPLUG_ENABLE;
+		I915_WRITE(VLV_ADPA, adpa_reg);
+	}
+
 	iir_mask = I915_DISPLAY_PORT_INTERRUPT |
 		   I915_DISPLAY_PIPE_A_EVENT_INTERRUPT |
 		   I915_DISPLAY_PIPE_B_EVENT_INTERRUPT;
@@ -3645,8 +3652,15 @@ static void valleyview_display_irqs_uninstall(struct drm_i915_private *dev_priv)
 {
 	u32 pipestat_mask;
 	u32 iir_mask;
+	u32 adpa_reg;
 	enum pipe pipe;
 
+	if (IS_VALLEYVIEW(dev_priv)) {
+		adpa_reg = I915_READ(VLV_ADPA);
+		adpa_reg &= ~ADPA_CRT_HOTPLUG_ENABLE;
+		I915_WRITE(VLV_ADPA, adpa_reg);
+	}
+
 	iir_mask = I915_DISPLAY_PORT_INTERRUPT |
 		   I915_DISPLAY_PIPE_A_EVENT_INTERRUPT |
 		   I915_DISPLAY_PIPE_B_EVENT_INTERRUPT;
-- 
2.5.5