[PATCH 1/3] adv7511: always update CEC irq mask

[Hans Verkuil]

From: Hans Verkuil <hans.verkuil at cisco.com>

Instead of doing:

	if (state->cec_enabled_adap)
		adv7511_wr_and_or(sd, 0x95, 0xc0, enable ? 0x39 : 0x00);

do:

	adv7511_wr_and_or(sd, 0x95, 0xc0,
			  (state->cec_enabled_adap && enable) ? 0x39 : 0x00);

This ensures that the cec irq mask is always updated correctly according
to both conditions.

Signed-off-by: Hans Verkuil <hans.verkuil at cisco.com>
---
 drivers/media/i2c/adv7511.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/media/i2c/adv7511.c b/drivers/media/i2c/adv7511.c
index 002117b..ddcde2d 100644
--- a/drivers/media/i2c/adv7511.c
+++ b/drivers/media/i2c/adv7511.c
@@ -937,8 +937,8 @@ static void adv7511_set_isr(struct v4l2_subdev *sd, bool enable)
 	else if (adv7511_have_hotplug(sd))
 		irqs |= MASK_ADV7511_EDID_RDY_INT;
 
-	if (state->cec_enabled_adap)
-		adv7511_wr_and_or(sd, 0x95, 0xc0, enable ? 0x39 : 0x00);
+	adv7511_wr_and_or(sd, 0x95, 0xc0,
+			  (state->cec_enabled_adap && enable) ? 0x39 : 0x00);
 
 	/*
 	 * This i2c write can fail (approx. 1 in 1000 writes). But it
-- 
2.8.1