[PATCH 30/36] drm/omap: poll only connectors where the connect/disconnect can be checked

[Tomi Valkeinen]

From: Peter Ujfalusi <peter.ujfalusi at ti.com>

When the connector associated detect callback is not provided, we can not
detect if the display is connected or disconnected. These displays does not
support hot plug, they are always connected. Let DRM know that connectors
w/o detect callback should not be polled.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi at ti.com>
Signed-off-by: Tomi Valkeinen <tomi.valkeinen at ti.com>
---
 drivers/gpu/drm/omapdrm/omap_connector.c | 10 ++++------
 1 file changed, 4 insertions(+), 6 deletions(-)

diff --git a/drivers/gpu/drm/omapdrm/omap_connector.c b/drivers/gpu/drm/omapdrm/omap_connector.c
index 2580e8673908..da53df4811ac 100644
--- a/drivers/gpu/drm/omapdrm/omap_connector.c
+++ b/drivers/gpu/drm/omapdrm/omap_connector.c
@@ -229,13 +229,11 @@ struct drm_connector *omap_connector_init(struct drm_device *dev,
 				connector_type);
 	drm_connector_helper_add(connector, &omap_connector_helper_funcs);
 
-#if 0 /* enable when dss2 supports hotplug */
-	if (dssdev->caps & OMAP_DSS_DISPLAY_CAP_HPD)
-		connector->polled = 0;
-	else
-#endif
+	if (dssdev->driver->detect)
 		connector->polled = DRM_CONNECTOR_POLL_CONNECT |
-				DRM_CONNECTOR_POLL_DISCONNECT;
+				    DRM_CONNECTOR_POLL_DISCONNECT;
+	else
+		connector->polled = 0;
 
 	connector->interlace_allowed = 1;
 	connector->doublescan_allowed = 0;
-- 
2.7.4