[PATCH v5 04/12] drm: bridge: analogix: Destroy connector & encoder when unbinding

[Andrzej Hajda]

On 06.04.2017 14:31, Jeffy Chen wrote:
> Normally we do this in drm_mode_config_cleanup. But:
> 1/ analogix dp's connector is allocated in bind, and freed after unbind.
> So we need to destroy it in unbind to avoid further access.
> 2/ the drm bridge is attached in bind, and detached in encoder cleanup.
> So we need to destroy encoder in unbind.
>
> Signed-off-by: Jeffy Chen <jeffy.chen at rock-chips.com>

In general drm core should free drm resources, doing it in component can
hurt some day. Maybe it would be good to move some stuff from
bind/unbind to probe/remove if necessary, to allow connector and encoder
to live little bit longer, and be destroyed by drm core. This is just
suggestion, I am not familiar enough with the driver to make stronger
statements :)

Reviewed-by: Andrzej Hajda <a.hajda at samsung.com>

 --
Regards
Andrzej


> ---
>
> Changes in v5: None
> Changes in v4:
> Address Andrzej Hajda <a.hajda at samsung.com>'s comments.
>
> Changes in v3: None
> Changes in v2: None
>
>  drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 2 ++
>  1 file changed, 2 insertions(+)
>
> diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> index d05ade4..4c758ed 100644
> --- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> +++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
> @@ -1439,6 +1439,8 @@ void analogix_dp_unbind(struct device *dev, struct device *master,
>  	struct analogix_dp_device *dp = dev_get_drvdata(dev);
>  
>  	analogix_dp_bridge_disable(dp->bridge);
> +	dp->connector.funcs->destroy(&dp->connector);
> +	dp->encoder->funcs->destroy(dp->encoder);
>  
>  	if (dp->plat_data->panel) {
>  		if (drm_panel_unprepare(dp->plat_data->panel))