[PATCH RFC 1/7] clk: samsung: Add enable/disable operation for PLL36XX clocks

[Krzysztof Kozlowski]

On Mon, Apr 24, 2017 at 1:12 PM, Sylwester Nawrocki
<s.nawrocki at samsung.com> wrote:
> On 04/22/2017 05:22 PM, Krzysztof Kozlowski wrote:
>>> @@ -354,10 +359,12 @@ static int samsung_pll36xx_set_rate(struct clk_hw
>>> *hw, unsigned long drate,
>>>         writel_relaxed(pll_con1, pll->con_reg + 4);
>>>
>>>         /* wait_lock_time */
>>> -       do {
>>> -               cpu_relax();
>>> -               tmp = readl_relaxed(pll->con_reg);
>>> -       } while (!(tmp & (1 << PLL36XX_LOCK_STAT_SHIFT)));
>
>
> I will add a comment here like:
> /* Wait until the PLL is locked if it is enabled. */
>
>>> +       if (pll_con0 & BIT(pll->enable_offs)) {
>>
>>
>> Why this additional if() is needed?
>
>
> The PLL will never transition to a locked state if it is disabled, without
> this test we would end up with an indefinite loop below.

Hmmm... shouldn't this be split from this change? Or maybe this is
needed only because you added enable/disable for pl36xx and previously
this was not existing?

Best regards,
Krzysztof