[PATCH v2 09/10] dt-bindings: exynos5433-decon: remove i80-if-timings property

[Andrzej Hajda]

Since i80/command mode is determined in runtime by propagating info
from panel this property can be removed.

Signed-off-by: Andrzej Hajda <a.hajda at samsung.com>
---
 .../devicetree/bindings/display/exynos/exynos5433-decon.txt  | 12 ------------
 1 file changed, 12 deletions(-)

diff --git a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
index 549c538..fc25882 100644
--- a/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
+++ b/Documentation/devicetree/bindings/display/exynos/exynos5433-decon.txt
@@ -25,12 +25,6 @@ Required properties:
 	 size-cells must 1 and 0, respectively.
 - port: contains an endpoint node which is connected to the endpoint in the mic
 	node. The reg value muset be 0.
-- i80-if-timings: specify whether the panel which is connected to decon uses
-		  i80 lcd interface or mipi video interface. This node contains
-		  no timing information as that of fimd does. Because there is
-		  no register in decon to specify i80 interface timing value,
-		  it is not needed, but make it remain to use same kind of node
-		  in fimd and exynos7 decon.
 
 Example:
 SoC specific DT entry:
@@ -59,9 +53,3 @@ decon: decon at 13800000 {
 		};
 	};
 };
-
-Board specific DT entry:
-&decon {
-	i80-if-timings {
-	};
-};
-- 
2.7.4