[Intel-gfx] [PATCH] drm/dp: Power cycle display if LINK_ADDRESS fails.
Pandiyan, Dhinakaran
dhinakaran.pandiyan at intel.com
Fri Dec 22 01:06:22 UTC 2017
On Thu, 2017-12-21 at 10:52 -0800, Manasi Navare wrote:
> On Wed, Dec 20, 2017 at 10:36:24PM -0800, Dhinakaran Pandiyan wrote:
> > Occasionally there are LINK_ADDRESS sideband messages timing out with the
> > Lenovo MST dock + Dell MST monitor(w/ in-built branch) setup I have. These
> > failures lead to the display not coming up on boot. Power cycling the port
> > corresponding to the MST monitor's branch device and resending the message
> > fixes the issue. I am not entirely sure if this is specific to my setup.
> > However, as the power state is toggled conditionally on LINK_ADDRESS
> > timeouts, this should not affect the working cases.
> >
>
> > Cc: Lyude <lyude at redhat.com>
> > Cc: Dave Airlie <airlied at redhat.com>
> > Cc: Jani Nikula <jani.nikula at intel.com>
> > Signed-off-by: Dhinakaran Pandiyan <dhinakaran.pandiyan at intel.com>
> > ---
> > drivers/gpu/drm/drm_dp_mst_topology.c | 13 +++++++++++--
> > 1 file changed, 11 insertions(+), 2 deletions(-)
> >
> > diff --git a/drivers/gpu/drm/drm_dp_mst_topology.c b/drivers/gpu/drm/drm_dp_mst_topology.c
> > index 70dcfa58d3c2..e06defcdcf18 100644
> > --- a/drivers/gpu/drm/drm_dp_mst_topology.c
> > +++ b/drivers/gpu/drm/drm_dp_mst_topology.c
> > @@ -1596,8 +1596,9 @@ static void drm_dp_send_link_address(struct drm_dp_mst_topology_mgr *mgr,
> > int len;
> > struct drm_dp_sideband_msg_tx *txmsg;
> > int ret;
> > + int attempts = 5;
> >
>
> Does the spec say this should be retried 5 times or is this just an
> experimental number?
The spec. does not say how many times to retry, but it does say the
source is responsible for retrying.
> We have such magical numbers for retries all over the DP code and that makes debugging
> harder later, so atleast a comment of why its 5 would help.
Takes about 22 seconds from boot to complete 5 retries on my SKL, I
think that's enough trying from the kernel side before pulling out the
DP cable makes sense :)
>
> > - txmsg = kzalloc(sizeof(*txmsg), GFP_KERNEL);
> > +retry: txmsg = kzalloc(sizeof(*txmsg), GFP_KERNEL);
> > if (!txmsg)
> > return;
> >
> > @@ -1635,9 +1636,17 @@ static void drm_dp_send_link_address(struct drm_dp_mst_topology_mgr *mgr,
> > }
> > (*mgr->cbs->hotplug)(mgr);
> > }
> > + } else if (attempts--) {
>
> This should be --attempts if you want the total attempts to be 5
I don't.
>
> Manasi
>
> > + kfree(txmsg);
> > + drm_dp_send_power_updown_phy(mstb->mgr, mstb->port_parent,
> > + false);
> > + drm_dp_send_power_updown_phy(mstb->mgr, mstb->port_parent,
> > + true);
> > + DRM_DEBUG_KMS("link address failed %d, retrying\n", ret);
> > + goto retry;
> > } else {
> > mstb->link_address_sent = false;
> > - DRM_DEBUG_KMS("link address failed %d\n", ret);
> > + DRM_DEBUG_KMS("link address failed %d, giving up\n", ret);
> > }
> >
> > kfree(txmsg);
> > --
> > 2.11.0
> >
> > _______________________________________________
> > dri-devel mailing list
> > dri-devel at lists.freedesktop.org
> > https://lists.freedesktop.org/mailman/listinfo/dri-devel
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx at lists.freedesktop.org
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
More information about the dri-devel
mailing list