[PATCH 3/4] phy: rockchip-typec: support DP phy switch

[Chris Zhong]

There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence
only one PHY can connect to DP controller at one time, the other should
be disconnected. The GRF_SOC_CON26 register has a switch bit to do it,
set this bit means enable PHY 1, clear this bit means enable PHY 0.

Signed-off-by: Chris Zhong <zyw at rock-chips.com>
---

 drivers/phy/phy-rockchip-typec.c | 9 +++++++++
 1 file changed, 9 insertions(+)

diff --git a/drivers/phy/phy-rockchip-typec.c b/drivers/phy/phy-rockchip-typec.c
index 7cfb0f8..1604aaa 100644
--- a/drivers/phy/phy-rockchip-typec.c
+++ b/drivers/phy/phy-rockchip-typec.c
@@ -267,6 +267,7 @@ struct rockchip_usb3phy_port_cfg {
 	struct usb3phy_reg usb3tousb2_en;
 	struct usb3phy_reg external_psm;
 	struct usb3phy_reg pipe_status;
+	struct usb3phy_reg uphy_dp_sel;
 };
 
 struct rockchip_typec_phy {
@@ -736,6 +737,7 @@ static const struct phy_ops rockchip_usb3_phy_ops = {
 static int rockchip_dp_phy_power_on(struct phy *phy)
 {
 	struct rockchip_typec_phy *tcphy = phy_get_drvdata(phy);
+	struct rockchip_usb3phy_port_cfg *cfg = &tcphy->port_cfgs;
 	int new_mode, ret = 0;
 	u32 val;
 
@@ -766,6 +768,8 @@ static int rockchip_dp_phy_power_on(struct phy *phy)
 		tcphy_phy_init(tcphy, new_mode);
 	}
 
+	property_enable(tcphy, &cfg->uphy_dp_sel, 1);
+
 	ret = readx_poll_timeout(readl, tcphy->base + DP_MODE_CTL,
 				 val, val & DP_MODE_A2, 1000,
 				 PHY_MODE_SET_TIMEOUT);
@@ -869,6 +873,11 @@ static int tcphy_parse_dt(struct rockchip_typec_phy *tcphy,
 	if (ret)
 		return ret;
 
+	ret = tcphy_get_param(dev, &cfg->uphy_dp_sel,
+			      "rockchip,uphy-dp-sel");
+	if (ret)
+		return ret;
+
 	tcphy->grf_regs = syscon_regmap_lookup_by_phandle(dev->of_node,
 							  "rockchip,grf");
 	if (IS_ERR(tcphy->grf_regs)) {
-- 
2.6.3