[PATCH 2/9] gpu: ipu-v3: add DT binding for the Prefetch Resolve Engine

[Philipp Zabel]

On Fri, 2017-02-17 at 19:28 +0100, Lucas Stach wrote:
> The Prefetch Resolve Engine is a prefetch and tile resolve engine
> which prefetches display data from DRAM to an internal SRAM region.
> It has a single clock for configuration register access and the
> functional units. A single shared interrupt is used for status and
> error signaling.
> 
> The only external dependency is the SRAM region to use for the
> prefetch double buffer.
> 
> Signed-off-by: Lucas Stach <l.stach at pengutronix.de>
> ---
>  .../bindings/display/imx/fsl-imx-drm.txt           | 26 ++++++++++++++++++++++
>  1 file changed, 26 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/display/imx/fsl-imx-drm.txt b/Documentation/devicetree/bindings/display/imx/fsl-imx-drm.txt
> index 971c3eedb1c7..1bd777d7c37d 100644
> --- a/Documentation/devicetree/bindings/display/imx/fsl-imx-drm.txt
> +++ b/Documentation/devicetree/bindings/display/imx/fsl-imx-drm.txt
> @@ -53,6 +53,32 @@ ipu: ipu at 18000000 {
>  	};
>  };
>  
> +Freescale i.MX PRE (Prefetch Resolve Engine)
> +============================================
> +
> +Required properties:
> +- compatible: should be "fsl,imx6qp-pre"
> +- reg: should be register base and length as documented in the
> +  datasheet
> +- clocks : phandle to the PRE axi clock input, as described
> +  in Documentation/devicetree/bindings/clock/clock-bindings.txt and
> +  Documentation/devicetree/bindings/clock/imx6q-clock.txt.
> +- clock-names: should be "axi"
> +- interrupts: should contain the PRE interrupt
> +- fsl,ocram: phandle pointing to the mmio-sram device node, that should be
> +  used for the PRE SRAM double buffer.
> +
> +example:
> +
> +pre at 021c8000 {
> +	compatible = "fsl,imx6qp-pre";
> +	reg = <0x021c8000 0x1000>;
> +	interrupts = <GIC_SPI 90 IRQ_TYPE_EDGE_RISING>;
> +	clocks = <&clks IMX6QDL_CLK_PRE0>;
> +	clock-names = "axi";
> +	fsl,ocram = <&ocram2>;

Nitpick: the CODA property for this is called iram. Should we do the
same here in case the PRE is later used on other SoCs that call their
on-chip SRAM differently?
There is no mention of OCRAM in the PRE chapter in the i.MX6QP reference
manual, but Figures 38-1 and 38-5 mention an "IRAM Double Buffer".

> +};
> +
>  Parallel display support
>  ========================
>  

regards
Philipp