[PATCH v8 3/3] arm64: dts: exynos: Add support for S6E3HA2 panel device on TM2 board

[Inki Dae]

2017년 01월 11일 16:46에 Andrzej Hajda 이(가) 쓴 글:
> On 11.01.2017 07:33, Hoegeun Kwon wrote:
>> From: Hyungwon Hwang <human.hwang at samsung.com>
>>
>> This patch add the panel device tree node for S6E3HA2 display
>> controller to TM2 dts.
>>
>> Signed-off-by: Hyungwon Hwang <human.hwang at samsung.com>
>> Signed-off-by: Andrzej Hajda <a.hajda at samsung.com>
>> Signed-off-by: Chanwoo Choi <cw00.choi at samsung.com>
>> Signed-off-by: Hoegeun Kwon <hoegeun.kwon at samsung.com>
>> Tested-by: Chanwoo Choi <cw00.choi at samsung.com>
>> ---
>>  arch/arm64/boot/dts/exynos/exynos5433-tm2.dts | 12 ++++++++++++
>>  1 file changed, 12 insertions(+)
>>
>> diff --git a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
>> index ddba2f8..6d362f9 100644
>> --- a/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
>> +++ b/arch/arm64/boot/dts/exynos/exynos5433-tm2.dts
>> @@ -18,6 +18,18 @@
>>  	compatible = "samsung,tm2", "samsung,exynos5433";
>>  };
>>  
>> +&dsi {
>> +	panel at 0 {
>> +		compatible = "samsung,s6e3ha2";
>> +		reg = <0>;
>> +		vdd3-supply = <&ldo27_reg>;
>> +		vci-supply = <&ldo28_reg>;
>> +		reset-gpios = <&gpg0 0 GPIO_ACTIVE_LOW>;
>> +		enable-gpios = <&gpf1 5 GPIO_ACTIVE_HIGH>;
>> +		te-gpios = <&gpf1 3 GPIO_ACTIVE_HIGH>;
> The same here (as in 1st comment) , te-gpios should be dropper - decon
> uses hw-trigger.

Reasonable to remove te-gpios property but this change would make MIPI-DSI driver probing to be failed so MIPI-DSI driver should be fixed together.

Thanks.

> 
> Regards
> Andrzej
>> +	};
>> +};
>> +
>>  &hsi2c_9 {
>>  	status = "okay";
>>  
> 
> 
> 
>