[PATCH 10/12] firmware: qcom_scm: Add qcom_scm_gpu_zap_resume()

[Andy Gross]

On Mon, Nov 28, 2016 at 12:28:35PM -0700, Jordan Crouse wrote:
> Add an interface to trigger the remote processor to reinitialize the GPU
> zap shader on power-up.
> 
> Signed-off-by: Jordan Crouse <jcrouse at codeaurora.org>
> ---

<snip>

> +int __qcom_scm_gpu_zap_resume(struct device *dev)
> +{
> +	struct qcom_scm_desc desc = {0};
> +	struct arm_smccc_res res;
> +	int ret;
> +
> +	desc.args[0] = 0;
> +	desc.args[1] = 13;

Can I get a define here for these two?  Or maybe a comment on what these values
are?

> +	desc.arginfo = QCOM_SCM_ARGS(2);
> +
> +	ret = qcom_scm_call(dev, QCOM_SCM_SVC_BOOT, 0x0A, &desc, &res);

Same with the 0xA.  We usually throw a #define in for the command definitions.

Otherwise this all looks fine.  If you can get back to me with either the values
or a new patch I can include this in the next pull.

Thanks.

Andy