[PATCH 6/6] drm/bridge: adv7511: Re-write the i2c address before EDID probing

[John Stultz]

I've found that by just turning the chip on and off via the
POWER_DOWN register, I end up getting i2c_transfer errors on
HiKey.

Investigating further, it seems some of the register state in
the regmap cache is getting lost, likely as the device registers
were reset during power off.

Thus this patch simply re-writes the i2c address to the
ADV7511_REG_EDID_I2C_ADDR register to ensure its properly set
before we try to read the EDID data.

Cc: David Airlie <airlied at linux.ie>
Cc: Archit Taneja <architt at codeaurora.org>
Cc: Wolfram Sang <wsa+renesas at sang-engineering.com>
Cc: Lars-Peter Clausen <lars at metafoo.de>
Cc: Laurent Pinchart <laurent.pinchart at ideasonboard.com>
Cc: dri-devel at lists.freedesktop.org
Signed-off-by: John Stultz <john.stultz at linaro.org>
---
v4: New approach to make the EDID_I2C_ADDR register
    sane, as suggested by Laurent
---
 drivers/gpu/drm/bridge/adv7511/adv7511_drv.c | 10 +++++++++-
 1 file changed, 9 insertions(+), 1 deletion(-)

diff --git a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
index d216f61..0ed89ea 100644
--- a/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
+++ b/drivers/gpu/drm/bridge/adv7511/adv7511_drv.c
@@ -573,9 +573,17 @@ static int adv7511_get_modes(struct adv7511 *adv7511,
 	unsigned int count;
 
 	/* Reading the EDID only works if the device is powered */
-	if (!adv7511->powered)
+	if (!adv7511->powered) {
+		unsigned int edid_i2c_addr =
+					(adv7511->i2c_main->addr << 1) + 4;
+
 		__adv7511_power_on(adv7511);
 
+		/* Reset the EDID_I2C_ADDR register as it might be cleared */
+		regmap_write(adv7511->regmap, ADV7511_REG_EDID_I2C_ADDR,
+			     edid_i2c_addr);
+	}
+
 	edid = drm_do_get_edid(connector, adv7511_get_edid_block, adv7511);
 
 	if (!adv7511->powered)
-- 
2.7.4